Vaporesso Target from Heaven Gifts

[greasegizzard]

I just got my vaporesso Target 75VTC kit from the contest Heaven Gifts had going here. Much thanks to them and @Vera and Evan for the contest. Great customer service and fast shipping. Made it here in 2-3 days.

My intitial thoughts on the kit... It's a little bit smaller than I expected it to be, but it still fits nicely in either hand and feels nice. It has a very solid feel to it. The magnets on the battery door are nice and strong, no rattle. All the buttons are solid and clicky. The screen is bright and sharp, more so than my iStick TC60W.

I wish the tank was a little bigger. The design only lets you fill it about half way or so. I wish it had top fill, too. It's a little tighter draw than I like, but seems to work well for the tank and coil. I like that the AFC has a pin to stop it from spinning all the way around. I'm about halfway through my first tank with the Ni200 coil and, like others have, the flavor is starting to come alive. I'm using a flavor I haven't tried before. I should have used one I had already been using, just for the sake of comparison. The first couple vapes really seemed to hit my chest hard, but that could be because of a new flavor or that I havent used temp control in a while. I went and got four new bottles of juice so I'm looking forward trying them out.

 

[greasegizzard]

Started my second tank with the Ni200 cCell with a different flavor. Flavor change was quick and smooth, two hits of old flavor, two or three hits mixed, then nothing but new flavor.

So I did a little swapping around just for grins and giggles. I took the Target tank with the Ni200 coil and put it on my iStick TC60W. The iStick will let you set max watts in temp mode. I had it set at the same temp as the Target but and got virtually no flavor or vapor from it even at max watts. So then I tried my TFV4 on the Target with a dual rba kanthal at .27 ohms I had been running at 45 watts on the iStick. Same watts on the Target with a much better hit, both flavor and vapor. Also the TFV4 fit nicely on the Target.

 

[greasegizzard]

 

[greasegizzard]

My screen did this today. I took the battery out and pot it back in. It did it again after one hit. That was with an LG HG2. I put a fresh Samsung 25R in, hasn't done it in a couple of hits so far. I had been holding it in my hand for a while, and the screen felt a little warmer than I had noticed before, so I'm thinking that could be the cause. Or maybe a glitch with the low battery display. I'll watch this one and see if it does it again when it gets low.

 

[KittyVapes]

I bought mine yesterday and mine is doing the same thing. It happened after about 4 hours so I took out the battery and out in a new LG HE4. Problem went away until today (day 2).....same issue. I am heartbroken because I wanted this mod and tank to work well and it is a stunning metallic purple color! Love the feel of it and the vapor and true flavor are amazing. I popped the tank on my old ClouporT5 until I can return this to my local vape shop. Will update then.

 

[greasegizzard]

Yeah, I'm kind of sad about it. But it's really more of an annoyance. I usually charge my batteries around half, maybe abit lower anyway. Had I bought it, though, I would definitely be exchanging it.

 

[KittyVapes]

Yeah, I'm kind of sad about it. But it's really more of an annoyance. I usually charge my batteries around half, maybe abit lower anyway. Had I bought it, though, I would definitely be exchanging it.

Why charge to half?

 

[greasegizzard]

Why charge to half?

Poor wording on my part. I discharge to half or a bit less, then recharge. :0)

 

[greasegizzard]

Just wanted to say thanks to @Vera and Evan from Heaven Gifts. He has sent me a replacement. The whole experience was hassle free. Above and beyond customer service!

 

[greasegizzard]

Thanks to @Vera Evan at Heaven Gifts for the replacement. The black is super schmexy!

 

[greasegizzard]

While I'm here, I figured I would give an update. I had to quit using the cCells for about a week or two. I had been using 6mg nicotine juice. When I started using the cCells, I started getting a headache every time I would vape after about three or four pulls on it. I stopped using them and went back to an rba I had. Once I got my juice cut down to around 3mg nicotine, I immediately went back to the cCells. I've been using them for a couple of days now with no headaches. I love the mod! No cons that I've found so far, except the issue with the screen. The tank I still find a little lacking, mainly just because it doesn't have top fill. It's also just a little tighter draw than I like, but it does provide adequate airflow for the cCells. I've been using the kanthal coil in my Melo 2, and I'm enjoying it much better.

 

[Acer50]

I got mine today and I must say yes its a dream, the Ceramic coil was great, I used the Ni200 coil, however I noticed the coil recognition feature did not work. Has any one else experienced this? Ok, played around with other TC tanks I have and they have the ordinary Ni200 coils not the ceramic like the Kangarteck OCC coil with the blue band. The Vaporesso coil was far superior in taste and flavour. Running mine now at 500F on the cCoil and truly fantastic. However when I tried the Kangarteck tank with the Ni200 coil it tasted like cr... and I had to drop the temperature way down to about 380F before I got nice flavour. I bought mine in Australia from Aussie E Cigs and the service and delivery was great.

 

[greasegizzard]

The coil recognition only works one way. So if you are in TC mode and put a kanthal coil on, it will tell you "Not Ni200" and switch to power. But it won't do it if you're in power mode and put a Ni200 coil on.

 

[greasegizzard]

I'm not a fan of TC in general. I've tried it on a few devices...not for me. I very much prefer the kanthal cCells. I hopefully can get a mod that does stainless in TC soon. I've heard good things about stainless.

 

[Fresh kevin]

That set up looks awesome on black! Definitely will look into one if I decide to upgrade

 

[greasegizzard]

That set up looks awesome on black! Definitely will look into one if I decide to upgrade

I actually like the white and orange best. I'm trying to find someone to trade with, but not having much luck. lol

 

[crxess]

Just glad to hear you got it sorted. Seems a lot of the early runs had the display issue. Hope they have resolved as the mod is a sweet looking piece and the pricing is right.

 

[greasegizzard]

Yep, me too. Evan and Heaven Gifts took care of it.

 

[Acer50]

The coil recognition only works one way. So if you are in TC mode and put a kanthal coil on, it will tell you "Not Ni200" and switch to power. But it won't do it if you're in power mode and put a Ni200 coil on.

Thanks, I tried that, as that is what my other TC mods do or simply switch to Watt mode in the event of a Kanthal coil. This one I have switched tanks, one with Ni Coil the other with Kanthal, and nothing happened even the new load screen only shows up occasionally. it remained in TC mode and no the resistance was not locked.

Looking at Heavensgifts site they say the following:

Automatic atomizer recognition: The mode will ask the user if a new atomizer is attached. " OLD LOAD-, New LOAD+" will appear on the display. Press "+", the mode will read new resistance; press "-" the mod will read at locked resistance.

My other TC Mods ask me what type of coil is it, Ni,Ti or SS this one does not so I suppose it Auto recognises the coil build material am I correct. I think so as it worked fine with all my RBA builds.
I looked at the review on YouTube, the only one so far.

this is the movie link I could not embed the movie here.

I also never vaped on a ceramic coil and yes I agree with the reviewer that the Ceramic coils are far superior to any other coil or build I have ever used. Although in Australia the only one I have ever found that sells the coils charges a fortune for replacement ceramic coils.

The coil recognition only works one way. So if you are in TC mode and put a kanthal coil on, it will tell you "Not Ni200" and switch to power. But it won't do it if you're in power mode and put a Ni200 coil on.

Nope mine ask if its a new load or old load (I am in TC mode when I do the switch) All it asks me is new or old load and I answer new and press the fire button and it is still in TC mode and does not switch to Watt mode.

 

[greasegizzard]

That's odd. Mine is the opposite. It never asks about the new coil, but it always recogizes it is not an Ni200 coil.