In a regulated mod you'll get roughly double the capacity, same as with regulated parallel mods. On mech mods you don't.
Sent from my M7_PLUS using Tapatalk
Voopoo Drag
- Thread starter USMCotaku
- Start date
- th_trl_thread_readers 0
- Status
Sent from my M7_PLUS using Tapatalk
Sorry for off...In a regulated mod running batteries in series we should use this formula
Btc(Bat total capacity)=(B1*B2)/(B1+B2) i will take HG2 in this case
Btc=(3000*3000)/(3000+3000)
Btc=9000000/6000
Btc=1500mAh
From this formula above,when batteries run in series you get half capacity of one batt...Thats what i found,it sounds odd...This formula was copied from Vape tool pro
Sent from my LG-D855 using Tapatalk
Btc(Bat total capacity)=(B1*B2)/(B1+B2) i will take HG2 in this case
Btc=(3000*3000)/(3000+3000)
Btc=9000000/6000
Btc=1500mAh
From this formula above,when batteries run in series you get half capacity of one batt...Thats what i found,it sounds odd...This formula was copied from Vape tool pro
Sent from my LG-D855 using Tapatalk
Last edited:
Ok it seems i worked out the issue.Update: I vaped somwere around 3ml on Ammit,45W,stil no drop showing on batt indicator
Sent from my LG-D855 using Tapatalk
It has gone to no battery bars on my second tank full! Just 6ml.
However, Since i last posted here, that is all i have vaped.. You see I am not a heavy vaper..
and the voopoo has been on all that time.. for example i have slept 3 times since then at least 8 hours each, and the voopoo has never been turned off. Perhaps unlike say my joyetech stuff (my cuboid has been on for 3 months now and still shows half way and i have used it a bit too), the voopoo drains when on?
If it's not supposed to, then it's definitely faulty and I will have to send it back (sigh).
3ML at 45w would go very quickly, so really in this case i think it's to do with how long it's on and not the vape time. for example that first tank i had vaped where it dropped one battery bar was over a full 24 hrs.
Ok.. but yihi devices and some other ones do, all my IPV6 ( i have 2 of them) and both yihi g and Q are the same.. so... are you sure drag is not that type of "drain" chip?
I might just buy a second one in resin even though i don't like the mod much and see if it's the same.
I really think i'd rather wear the loss with fasttech than deal with them for a return.
I might just buy a second one in resin even though i don't like the mod much and see if it's the same.
I really think i'd rather wear the loss with fasttech than deal with them for a return.
Milan, how many tanks of the 45W vape did you get, and which 18650 batteries did you have installed? I am about to try mine with 2xSony VTC6 just to be 100% sure.
I use LG HG2 mostly,somwhere around 4 tanks (5ml,but i refill when i have 0.5ml left in a tank).So anywhere from 18 to 20-21ml.I filled it up,and put some fresh batteries last night.Im gonna mesure ml's for you
Sent from my LG-D855 using Tapatalk
Sent from my LG-D855 using Tapatalk
Sorry for off...In a regulated mod running batteries in series we should use this formula
Btc(Bat total capacity)=(B1*B2)/(B1+B2) i will take HG2 in this case
Btc=(3000*3000)/(3000+3000)
Btc=9000000/6000
Btc=1500mAh
From this formula above,when batteries run in series you get half capacity of one batt...Thats what i found,it sounds odd...This formula was copied from Vape tool pro
Sent from my LG-D855 using Tapatalk
Battery life is the same. I explained it in my aspire blog. That info you copied isn't correct
Sent from my iPhone using Tapatalk
I need some plastic bottles for my e liquids and will probably order from 3FVape, the Voopoo Drag is selling for $40 there and I could order it at the same time. Besides the problems that Vesh is having with his device is this thing worth while. I'd be using it with SS, probably put on a Smok TFV8, dual .400 ohm coils at first, is the preheat power curve useful, has anyone updated the firmware, I don't see any amps.
Yes,its superb device.Temp control is working as it should,i tested SS and Ni200.Power/temp curves work,you can set them on the device and on Voopoo PC program...On my device battery life is great.Paint is durable (i put it in my pocket alot)...
Sent from my LG-D855 using Tapatalk
Sent from my LG-D855 using Tapatalk
While looking at the Voopoo vids I came across the Cartel Revenant 160 W which has a fourth button for mode select. To get a pre heat for TC you would have to go to one of the M modes it seems so far, costs 100 more than the Voopoo.
Thinking about this whole thing just maybe since I like the Smok so much and the price is now down for the Smok maybe just go with another Smok. Still not sure though.
Thinking about this whole thing just maybe since I like the Smok so much and the price is now down for the Smok maybe just go with another Smok. Still not sure though.
Have cartel already updated the revenant with omni chip 2 have they?
Cause the first ones had the same chip as the tarot's, etc, which has no pre head adjustability for TC.. it does have a tc curve mode though but still, it hits most coils way too hard vs other good tc mods. It tries to push 160 watts through a 25 watt coil lol if you have the temp as a warm vape.
Vaporesso have much improved TC with the new omni chip in their revenger mod, and that;s the vaporesso based mod to get if vape matters. For looks, revenant stunning, but to me only worth it when it has the new omni.
The Cartel has the Omni 2 chip, mentioned in this vid
he does a good job comparing the Voopoo vs the Cartel. I already have the Smok and a Pico 25 both with 25 mm tanks so I'm not in a rush to do anything.
he does a good job comparing the Voopoo vs the Cartel. I already have the Smok and a Pico 25 both with 25 mm tanks so I'm not in a rush to do anything.
While ordering e liquid batteries I also ordered the Voopoo, it'll take about a month for it to arrive.
The Cartel is nice looking, more rounded and easier on the hands, mode select is a nice feature but the price is to high.
The Cartel is nice looking, more rounded and easier on the hands, mode select is a nice feature but the price is to high.
Thanks so much.. the key here in what period of time?
I now have VTC6's in mine and they are making a difference, more like your HG2. The batteries i was using previously have 20% less capacity than yours so i had to make it an even test.
I am on 17 watts with the ego one mega tank which is 4.5ml i think, filled to the brim, i just got through a tank, with the VTc6, and on the very last puff the battery went down one. It took me 48 hours to get through that tank, voopoo was on the entire time. Judging this, i will get 20 mils over a week or so, this is starting to sound perfectly normal and just as i thought, it drains faster than a lot of other mods when left on.
Measuring current from the battery is easy enough, Radio Shack is shut down so getting a good meter could be hard.
Vesh's problem seems to be solved so it's not necessary.
Since I like the touch screens I did find the Smoant Charon TS 218 $60
Vesh's problem seems to be solved so it's not necessary.
Since I like the touch screens I did find the Smoant Charon TS 218 $60
I saw the mailman as he was bringing the package back to the truck so the package was delivered. It worked fine right out of the box, put in batteries and a Griffin tank .26 ohms SS and vaped it in temp mode 340 F as I walked the dog. Inside I had to try the Smok SS .36 ohm coil needed to turn the temp into the 200's then I tried changing the resistance, if you go to low in resistance it will stop firing, increasing it to .32 ohms allowed it to fire with a temp of 340 F. So it's doing the job for me. It seems the unit has been updated to the latest version already but I guess there are some downloads you can get for it.
- Status