VV REO Grand III
- Thread starter Rhapsodies Fire
- Start date
- th_trl_thread_readers 0
- Status
That finish is like "WOW!" Me likey!!!
Thanks Karen...
I love the texture.I was just doing a dry-burn on the ERA... I'm using 3mm Silica wick from Avid Vaper. Rebuildable Atomizer Coil Wick - Avid Vaper It's doubled on the coiled end, wrapped around, and pulled-through the bottom...
Here's a pic of the wick / coil:
A pic of my newly found vaping pal...
Oh Man! Is that the 'black wrinkled' finish? I've been lusting over that one for a while now. Hope there's one left after the holidays...
Happy this James Dean never made breakfast sausage but then again he never sang "Can't go huntin with you Jake but I'll go chasin women" which happens to be the flip side of the 45 that had "Big Bad John" on it. THen again if Jimmy Dean drove a Porsche 550 Spyder the freezer department would look different. Nice mod you have and a handsome coil to boot.
One last pic for piss & giggles...(Note: The knife is just a prop...
A pic of my newly found vaping pal...
That is 1 Bad ... setup you got there Lee
I have a question for you REO gods......I have my first REO, a VV Grand. The REO was purchased new. I understood that these took 18650 batteries. I have been using AW IMR 18650 2000mAh in most of my MODS...ProVari, GG's, Titanide, Zen, Cube,......bla bla bla
However in the REO there is a 1-2 mm gap.....I have had to add magnets to take up the space....
Is this normal?
Thank you for any advice
However in the REO there is a 1-2 mm gap.....I have had to add magnets to take up the space....
Is this normal?
Thank you for any advice
Kami, the vvgrand uses stacked batts - AW IMR 18350s.
RTD Vapor has them: AW IMR 18350 3.7V 700 mah Get yourself 3 sets. And keep them in sets when charging them and using them. 1 set = 2 batts
RTD Vapor has them: AW IMR 18350 3.7V 700 mah Get yourself 3 sets. And keep them in sets when charging them and using them. 1 set = 2 batts
Last edited:
The standard battery for the GRAND is an 18650, the standard batteries for the VV GRAND is two (2) 18350's.
Jack
(As usual I'm a day late and a dollar short.)
Jack
(As usual I'm a day late and a dollar short.)
OK...so the VV is a step-down thingy...from like around 8 volts to ??....Will this maintain the selected voltage until the batteries reach a nominal voltage level?
I have a question for you REO gods......I have my first REO, a VV Grand. The REO was purchased new. I understood that these took 18650 batteries. I have been using AW IMR 18650 2000mAh in most of my MODS...ProVari, GG's, Titanide, Zen, Cube,......bla bla bla
However in the REO there is a 1-2 mm gap.....I have had to add magnets to take up the space....
Is this normal?
Thank you for any advice
Kami - The VVG use two 18350 batteries.
Kami, the wheel goes from about 3.5 to 5.5 vaping. Turning the wheel right makes the vape warmer - to the left cooler. It is a regulated system so your first vape on a batt will be like your last vape.
What I did was get a paint pen at Beverlys and marked the 4.5 area of the wheel so I had an idea where I am.
What I did was get a paint pen at Beverlys and marked the 4.5 area of the wheel so I had an idea where I am.
Last edited:
It ranges from 3.7 to 5.5 volts and will maintain the selected voltage through shutdown. If I'm not mistaken it utilizes the BuzzPro electronics.
(I'll bet I'm late again.)
Jack
(I'll bet I'm late again.)
Jack
Welcome, Kami
Yes. You will notice decreased performance right before it cuts off, though.
- Status
