I finally got the gg clone in from hoosiers and the 28gage wire. The gg looks good, but I think they sent me in the wrong wire, its thinner than the 30gage (about the same as my 32gage) that I have had. I am disappointed about that. The GG looks great. It is thin metal, but solid just enough. The thing that I don't like is the button position, and sometimes I have to move (shake) the button a little to get a good connection. It is very easy to position the air hole of the genesis where I want it.
Provari and go as low as .8ohm and as high as 15W
I have always had the same confusion with the varying volt mods. Two days before I got the gg clone, I set up my did clone with a four wrap coil (30gage), giving me 1.2oms. The ProVeri would never fire on a 1.2om coil, only giving me an E code. So this time I tried using the 1.2om on my twists, and my new ITaste MVP. It does work on those two, but I found out that both of those devices (and I am guessing on all those VV VW devices), that even though I cranked up the voltages on them, they WOULD NOT supply the power I set to the atty. Because the protection circuit would limit the power.
In other words: The ProVeri will tell you the truth: "I will not power your 1.2 oms, so don't even ask!"
The others lie to us saying: "Look, I am working, set me to whatever!" while set on 5V, it will only give about 3.5V.
On the MVP I had it cranked to 5 volts, but it hit just like when I had it set to all the way down.
Not that I got the gg clone, it is hitting A LOT harder that it did when it was on the MVP set at 4v.
Tomorrow I'll be getting my new AGA T Plus from myvaporstore.com. Since Hoosier messed up my 28gage K wire, I am going to try a three wrap 30gage. I'll let you know more.