whats your nighttime setup ?

Status
Not open for further replies.

Lightgeoduck

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Aug 7, 2009
5,699
180
50
jp(APO)Camp Z us
I usually leave it assembled... but this is just a suggestion...

maybe have it next to your bed with a charged battery and the atty disassembled from the batt this way in the morning you still have to take steps to vape..... I would think that would be a good substitute to grabbing a cigarette and lighting it with a lighter.

that is if you were worried about still keeping your routine but with an ecig rather then a cigarette
 

Wheatfield

Full Member
ECF Veteran
When I was smoking I'd make a point of waiting 15-20 minutes before going at it in the morning, same thing with vaping. You can fill your wait time in with loading up your ecig. That is if you have any desire not roll out of bed and start your day vaping.

For me its an issue of not being controlled by a need to do something externally to "get by" although I feel much better about vaping than the cigs.
 

jj2

Moved On
ECF Veteran
May 30, 2009
196,879
212,801
Hundred Acre Wood
I make sure all carts I'm going to use the next day are loaded.
I'm usually up a couple hours before I take my first vape---was the same way with smoking.
I'm a "leave me to my silence" for a while after waking. RW says it takes me an hour to realize I'm awake.
Then I walk the dog.
Once that is done, I'm usually ready for my first vape of the day and I want everything ready.
 

jghunter1

Senior Member
ECF Veteran
Nov 13, 2009
197
0
52
Denver, N.C.
I'm a lazy .... I DON'T dissassemble my Joye 510 overnight. In fact, I usually have 3 semi-assembled PV's. One with "strong cuban cigar"- my "closest to analog go-to flavor"-super vital for the early AM nic-fit. I also keep a 555 flavor, and a mint/menthol/tobacco blend, attatched to separate attys's at all times. I do not clean or drain my atty's nightly. I'm a noob so only going about 3 weeks so far. I did have one atty go "nuclear" =burned without intentionally doing so. Fortunately, I noticed it was burning (even though LED did not turn on) I rinsed with plain H2O- blew out liquid, let dry full 48 hours, and still working just fine!
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread