wich is better for 1.5 atty?

[rob87]

hello fellow vaporers,
I currently use an glv supermini w/an 1.5 atty?Took it to the beach and almost lost it.
anyway I dont want to go through that again so I want to get a ego,kgo or igo or something else just not sure wich one.

Here is what i need.something that can use a 1.5 lr atty(I know anyone of these can use it),but wich would be better.
which is higher off the charger and stays there until charging.
which has the mosfet switch(this i think could cause a problem with the lr atties)
and also need a 510 threading.....might be to much to ask in one unit but hoping someone could help me...also not looking for any kind of mod,just something to tubular and inexpensive that wont kill me if i lost it.

 

[Kent C]

hello fellow vaporers,
I currently use an glv supermini w/an 1.5 atty?Took it to the beach and almost lost it.
anyway I dont want to go through that again so I want to get a ego,kgo or igo or something else just not sure wich one.

Here is what i need.something that can use a 1.5 lr atty(I know anyone of these can use it),but wich would be better.
which is higher off the charger and stays there until charging.
which has the mosfet switch(this i think could cause a problem with the lr atties)
and also need a 510 threading.....might be to much to ask in one unit but hoping someone could help me...also not looking for any kind of mod,just something to tubular and inexpensive that wont kill me if i lost it.

The SE Riva will give you 3.7v underload and will work well with a 1.5lr atty for dripping. But you'll be generating over 9 Watts so it may wash out some flavors. The eGo batt will get you around 7-7.5Watts... I run a cisco 1.5ohm 306 (510 threading) on a Riva VV batt at high (4.2v/3.9v underload) for coffee flavor and it works well. The VV will cost you more

 

[rob87]

what about the k go I hear they stay at around the 4.2 till the need charging