wicking issues

[c.chalie]

ok here it go, im lost with this one,
i have a lava tube, with 2 brand new 1.5ohm 306 attys (my old lr 306 work perfectly) but when i got them i primed them, put the drip tip on, took a few puffs, worked and tasted fine, when i added 3 more drops when it needed it, it will not wick into the atty, and i get a reallllly harsh dry hit, put i can see the juice sitting on top of my atty, so i lightly blow into it to get the juice down on the coil, and when i pull on it to vape, no madder how light i pull i suck the juice right back out of the atty, and again the juice will not wick back into the atty.

is it possible to have too much wick in there and thats "blocking" the juice?
or should i just pull off the bridge and try it bridgeless?

 

[c.chalie]

Maybe this will help, it just sits there and will not wick back into the atty

 

[Iffy]

Did you dry burn the 'manufacturing fluid' off prior to use? Do a dry burn and retry the atty.

 

[c.chalie]

I tryed to blow out the primer, when it first came in but was none in it, and also the website NHaler • Smoking Alternatives said there is no primer in them before shipping, but i did try to re-prime it with my juice 3 times just to be sure