hi guys i noticed that it leaks on me whenever i refill? is there any trick to it? please help me as i have wasted a significant amount of e liquid..
Wotofo Serpent Mini
- Thread starter Sed8op8
- Start date
- th_trl_thread_readers 0
- Status
When refilling, I close the afc, fill, thread the top cap on a few turns, turn it over, open the afc, then tighten top cap while upside down. Now turn it back right side up. This is what has worked for me.
This is the procedure I use, and it has alleviated that a lot, most of the time at least 100%:
Close air flow ring.
Refill. But not to the top.
Turn tank upside down.
Count fairly slowly to 5 or 10.
Turn right side up.
Open AFC.
Draw, but without firing, 2 or 3 times.
Good luck bud. I have absolutely come to almost want to marry this tank. My girl who I've been with for almost 20 years is jealous..
Last edited:
Oh yeah, I forgot to say that, but probably don't need to.. though I do remind myself to not do it again..
especially before turning the tank upside down.. 
Thanks guys, Ill try it out later, do you guys save on e liquid the fact that this tank does not need much power to get a flavorful vape???
Just a little tip for those folks that like a tight MTL draw. You can take the air flow plug from the MTL kayfun kit and pop it right into the Serpent Mini for a much better MTL experience.
Just wanted to say I real love this tank it's really easy to wick!
Are these kits available separately or do yo have to buy a Kafun to get it? Maybe this is what I need.
I was hoping they would give us a bigger one. I love how short it is but you burn through juice of an too fast with the low ml. Most of my tanks are 25mm now so being wider won't bother me a bit.
I was going to get the black version from Gearbest but I think I will wait to see if the bigger version comes out. Thanks for the heads up!
I haven't had a single drop leak from mine. I just pop the top and fill it, no whirling a chicken in the air, fifteen hail Mary's etc. I'm using 70/30 VG/PG, maybe it's an issue that affects higher PG mixes?
The only issue I've had is that I have to grip the pyrex first or when I try to take off the top cap I end up unscrewing the whole thing.
The only issue I've had is that I have to grip the pyrex first or when I try to take off the top cap I end up unscrewing the whole thing.
Ahhh, I found them. Gonna have to get a couple of those.
Svoe Mesto Kayfun 5 Mouth To Lung Kit - Origin Vape
Last edited:
Mine was leaky after filling with a 2,5mm coil, no problem at all from 3mm and upwards. I suspect it's all in the amount of wick, as usual.
I bought one because people said it didn't leak. You can find that in every thread of every RTA though. Like I've said, wicked just enough to not leak it was fine for most vaping, but if I wanted to crank up the watts I got dry hits. A little less wick I could crank it up, but it would leak. Tried 20 times different methods and lengths etc..... No go. It's in the box. I have no problem wicking my other tanks to not leak and allow me to crank up the power.
What is everyone favorite build to go into the Serpent Mini? i'm looking for new ideas to put in my tank 
What do you consider crank up the power? I am vaping mine at 50 watts with a 0.25ohm Flat Twisted SS1316 coil and it is very tasted with plenty of vapor. With such a small deck and chamber I cant imagine needing any more power than that.
It doesnt leak at all but I do get a slight bit of flooding on refill. Nothing major, just a couple of wet hits right after refilling.
That's not the issue. A 1.5ohm 3mm ID kanthal can't do those kind of numbers which is why I asked sonicbomb the build and power. What I'm saying is the SM can't handle the same build and wattage my other tanks can. It gives dry hits, unless I wick less which results in leaking. Make more sense?
6 wraps at 2.5mm 26/32 clapton at 28 watts. Initially with cotton, then with rayon which let me take longer hits and bump the wattage up to 30 watts.
If your orings are sound, then leaking is almost always down to wicking in my experience.
- Status
