THe connector dosent stick through at all. I think im going to countersink it ever so slightly to make a sort of juice well. Otherwise ill have over 1/8 of an inch below the connector. to the bottom side of the cap.Gummy, I don't think your pic allows for the angled sides, you've set them in the wall. The boosted 18650 would fit though. If the 8100W, then maybe 2 18500's and the circuitry running sideways along the top?? The connector probably wont stick in much, and the pot doesn't need to be on the board--This is looking tighter than I 1st thought...
Just a quick and dirty photoshop. Just trying to show that the batts don't have to go all the way down to the bottom/back wall.
Hey Ruppy,,,
What does the side measure?
And the bottom/back wall while your at it.
Ill have to measure in the morning I left the case on my desk at work. Each side of the back three sections of the hex are approximately 1 inch and the two front most sides are about 1/2 inch. Ill post more accurately in the morning.
Last edited: