Freemax Galex & Galex Nano // Review by HyDrOpOnIc1987
Hello, welcome to another of my reviews. Today we'll be taking a look at 2 devices in a series, the Galex Series. The devices are: The Galex and The Galex Nano. I hope to show you the similarities and differences between the devices, as well as help you decide whether either device would be right for you. I also hope to provide an honest and fair review of said devices. As usual, I will start by showing you some promotional images and then tell you some information about the devices. I'll then talk about the unboxing, assembly and usage of the devices. Alright, now let's get down to business.
Promotional Images, Features and Specifications
The Galex
Specifications:
Brand: Freemax
Unit: 1 Set
Size: 23.5*16.5*107.47mm
Pod Capacity: 2ml
Coil Resistance: 0.8/1.0ohm
Battery Capacity: 800mAh
Output Wattage: 11-16W
Output Voltage: 3.3-3.5V
Packaging: Box
Features:
Full Spectrum Vaping, Shine Like the Galaxy;
The Galex kit applies Freemax's typical Full-Spectrum (RGB) lighting design for a shining appearance and a better interactive vaping experience. It has multicolour and unicolour flashing modes that can be switched or turned off by putting the pod into the device twice within 3 seconds.
FM SaltCoilTech 4.0, Ultra Mouth-to-Lung Solution;
The core of FM SaltCoilTech 4.0 lies in the 50% increase in the tea fiber and the use of innovatively-quenched SS904L mesh, allowing vapers to enjoy the purest flavours from the first puff, while further improving the coil's lifespan.
FM Leak-Resistant Tech, Creative Maze Chimney Design;
The Galex's pod applies FM Leak-Resistant Technology with a maze chimney on either side of the pod. This tortuous chimney structure extends the path of the excess e-liquid flowing through the chimney, thus effectively preventing leaking issues.
Top-Filling Galex Pod, Compatible with GX Mesh Coils;
The Galex Pod is a 2ml Refillable cartridge with a top filling system and is compatible with GX Mesh Coils and all Galex series products. GX Mesh Coil currently comes in 0.8ohm (RDL vaping) and 1.0ohm (MTL vaping).
800mAh Rechargeable Battery, Large Enough for All-Day Vaping;
The Galex kit has a large 800mAh battery that can be fully charged in 40 minutes via the USB-C charging port and bring you a long-lasting vaping experience. During vaping and charging, the tiny LED lights up to indicate the battery level. Green is over 100-70%, Blue is 70-35% and Red is 35% and below.
Package Contents:
1pc Galex Kit
1pc GX Mesh Coil 0.8ohm
1pc GX Mesh Coil 1.0ohm (Pre-installed)
1pc Warning Card
1pc Warranty Card
1pc User Manual
1pc USB Type-C Cable
1pc Desiccant
The Galex Nano
Specifications:
Brand: Freemax
Unit: 1 Set
Size: 53*19*76.96mm
Pod Capacity: 2ml
Coil Resistance: 0.8/1.0ohm
Battery Capacity: 800mAh
Output Wattage: 11-22W
Output Voltage: 3.3V-3.5V-4.2V
Packaging: Box
Features:
Full Spectrum Vaping, Shine Like the Galaxy;
The Galex kit applies Freemax's typical Full-Spectrum (RGB) lighting design for a shining appearance and a better interactive vaping experience. It has multicolour and unicolour flashing modes that can be switched or turned off by putting the pod into the device twice within 3 seconds.
FM SaltCoilTech 4.0, Ultra Mouth-to-Lung Solution;
The core of FM SaltCoilTech 4.0 lies in the 50% increase in the tea fiber and the use of innovatively-quenched SS904L mesh, allowing vapers to enjoy the purest flavours from the first puff, while further improving the coil's lifespan.
FM Leak-Resistant Tech, Creative Maze Chimney Design;
The Galex's pod applies FM Leak-Resistant Technology with a maze chimney on either side of the pod. This tortuous chimney structure extends the path of the excess e-liquid flowing through the chimney, thus effectively preventing leaking issues.
3-Level Adjustable Output, Customize As You Wish;
The output level can be adjusted between low (3.3V, Red), middle (3.5V, Blue) and high (4.2V, Green) levels by clicking the side button 3 times, allowing vapers to customize their desired output level and achieve the ideal balance of flavour and vapour.
Top-Filling Galex Pod, Compatible with GX Mesh Coils;
The Galex Pod is a 2ml Refillable cartridge with a top filling system and is compatible with GX Mesh Coils and all Galex series products. GX Mesh Coil currently comes in 0.8ohm (RDL vaping) and 1.0ohm (MTL vaping).
800mAh Rechargeable Battery, Large Enough for All-Day Vaping;
The Galex kit has a large 800mAh battery that can be fully charged in 40 minutes via the USB-C charging port and bring you a long-lasting vaping experience. During vaping and charging, the tiny LED lights up to indicate the battery level. Green is over 100-70%, Blue is 70-35% and Red is 35% and below.
Package Contents:
1pc Galex Nano Kit
1pc GX Mesh Coil 0.8ohm
1pc GX Mesh Coil 1.0ohm
1pc Warning Card
1pc Warranty Card
1pc User Manual
1pc USB Type-C Cable
1pc Desiccant
Unboxing, Assembly and Usage Highlights
The boxes look very similar to the ones that the Maxus Solo 100W kit and the Marvos X kit both came in. Makes sense, they're very nice and catchy looking. They grab your attention very well. I will start with the Galex kit first: on the front of the sleeve it has the Freemax branding on top, a picture of the device in the colour included, the model name (Galex) and under that in small white font it has written the colour of the device, which in my case is Blue. The right side has Freemax's contact information and social media accounts, in case you need to contact them or need to do some research. The left side displays 4 main features of the device, which I wont repeat again because I have said the features a lot already. The back of the sleeve it has the device's specifications, the package contents, a warning (not for people under their legal smoking age, keep out of reach of children). There is also a “Scratch and Scan" sticker that has a QR code above it. Lastly is the UPC codes and more warnings under that.
Inside the box is the device with the pod and 1.0ohm coil inserted. Under that in another compartment is another coil (0.8ohm), a USB-C cable, warranty and manual booklet, a warning card and a desiccant.
After looking at the packaging, I took the device out and popped the pod and coil out and proceeded to rinse the pod out with hot water and then shook it dry. I then took the 1.0ohm coil that was already in the pod and started to prime the holes on the outside with some 10mg 50/50 salt nicotine liquid and then replaced the coil and filled the pod. The pod is top fill, you take the mouth-piece off and under is a fill port and a small tiny air hole on the opposite side of the chimney. Because of that, it fills easily and fast. I then put the pod down and waited 15 minutes before reinserting it in the device and then taking a couple draws.
After using the device for a while I was able to say that the MTL isn't the tightest, but should satisfy most MTL pod vapers. The coil's flavour is spot on. I've been using this device, along with the Galex Nano, for about 2 weeks and I still haven't had to change out either coil. I have gone through at least 7 fills each and the flavour hasn't dropped yet. It seems the 50% increase in tea fiber did the trick! I used the RGB lights at night when I went out, but mostly I kept the lights off and I noticed the battery lasted about an hour longer without the lights on. Of course, your mileage may vary.
Next I will take a look at the Galex Nano: the front of the sleeve houses the Freemax branding at the top, under that it says the colour of the device (Black), under that is a logo showing that this device uses FM SaltCoilTech 4.0. To the left of that is a picture of the device in the colour that is in the box. Under is the Galex Nano branding. On the right side of the sleeve it has Freemax's social media. The left side has the 4 main features of the Galex Nano. The back of the sleeve houses the specifications of the device, the contents of the package, a bunch of warnings, Freemax's contact info, a UPC code (or two), a “Scratch and Scan" sticker that has a QR code slightly above it. Lastly under that is a bunch on warning signs.
Like the other device, I took the device and pod out of the box and proceeded to take the coil out of the pod and rinse the pod in hot water and shake it dry. Next I took the 1.0ohm coil and put it away as I already had the 1.0ohm going in the Galex. So, I took the 0.8ohm coil out and proceeded to prime the holes on the outside with 10mg 50/50 salt nicotine liquid. Normally I would try some 70/30 in a RDL coil, but I wanted to guarantee it would work. I have had some bad luck trying to run 70/30 in RDL coils for small pod devices. It almost always ends up burning because it wont wick as quick. After priming the coil with the 50/50 salt nic liquid, I then reinserted the coil into the pod and filled it exactly as I did the other one. After waiting 15 minutes or so, I popped to pod back into the Galex Nano and made sure to set the device to low (Red). I want the device to be low powered for the first few puffs (10 to 15 min of light to medium vaping) to make sure that the oil doesn’t burn. After a bit of vaping on low (Red) I then took it to medium (Blue) for about 5 minutes or so and then bumped it up to high (Green). I kept it there for about 20 minutes (as I like warmer vapes and more clouds) but felt as though it would burn the coil out a little faster (was pretty warm on Green) so I dropped it back to medium (Blue) and kept it there for the whole time I reviewed these devices. Medium, to me, is the prefect balance of flavour and clouds, with a good warm vape but not being too hot. Reviewing the Galex Nano kind of reminded me of Goldilocks, to me Medium was “Just Right" lol
Like the other device, I ran this for about 2 weeks and haven't burnt the coil out yet. The flavour hasn't dropped yet either, mind you I was reviewing 3 devices at the same time so it couldn't get my undivided attention. But I’ve had coils last hours before, so the 2 weeks I have so far is really good IMO. The flavour of this coil was pretty much as good as the other, maybe slightly more so but probably because it’s been ran at a higher voltage.
Neither devices leaked a single drop in the 2 week test. Not from where the coil gets inserted, not from the airflow, not from the mouth-piece. Not. One. Drop.
The only difference I could see between the 2 devices was that the Nano had more colour options and had the ability to change it's voltage. Also, there's the appearance differences, but that's obvious.
I would recommend either of these devices to someone trying to quit smoking, someone moving over from disposables, or someone looking to upgrade their pod devices. The Galex kit I would recommend to anyone who just wants plug and play. No messing with voltages. The Galex Nano kit, I would recommend it to the person who wants a bit more control over their vape experience. Ultimately though, I think most people would be very happy with either device.
I would like to thank
Tina at
Freemax for sending me these devices to review. I would also like to thank
all of you for sitting through this long double review. It's been a pleasure writing this review for all of you. I hope you were able to learn something about these devices, and I hope this review has helped you decide whether to grab one of these devices.
I will provide a link to Freemax's website, as well as a link to both Galex kits.
Freemax website -
FREEMAX | FREE MAX. FLAVOR MAX.
The Galex kit –
Galex Kit | FREE MAX. FLAVOR MAX.
The Galex Nano Kit –
Galex Nano Kit | FREE MAX. FLAVOR MAX.
Thank you very much for reading, and I hope you check out my next one.
Cheers!