Best build for Avocado 24 Bottom Airflow?

Discussion in 'Rebuildable Atomizer Systems' started by TarekElsakka, Dec 12, 2016.

Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. TarekElsakka

    TarekElsakka Senior Member

    Oct 26, 2016
    I purchased it yesterday and I have a dual coil 24g 5 wraps on 3mm build installed at the moment. The flavor is very good, but not as good as I had hoped. I am sure there are better builds out there for flavor production. Should I try a single coil build instead?
     
  2. excalibur-x

    excalibur-x Full Member

    Nov 15, 2016
    I have same question, but for Avocado 22 and Griffin 25.


    My first tank was Tron-S. I tried many different builds and at the end I settled with 0.58 ohm coil build around 2mm screw. Taste this little tank gives me is great and outperforms Avocado 22 and Griffin 25.

    In Avocado 22 I have single SS316L, 26 gauge, 2.5mm, 9 wraps, 0.57ohm and in Griffin I have dual SS316L, 26 gauge, 3mm, 9 wraps 0.34ohm. All coils are spaced. Vapor production is great, but taste is so so. Not bad, but compared to Tron-S taste is diluted. Especially on Griffin. I also have Zephyrus V2 (dual contact coils, 26 gauge, 2mm, 8-9 wraps 0.25ohm) and with this tank taste is much better than Tron-S even when I completely open air flow. I get nice warm dens vapor at 35W and 230-240C.


    In Griffin I already tried Ti wire and contact SS coils but taste remained diluted. So, what should I build to improve taste in Avocado and Griffin. Smaller diameter coils, twisted, less wraps,…?
     
  3. TexanFan

    TexanFan Full Member

    Apr 16, 2012
    Spring Tx
    I use a SS 8 wrap on 3.5 dia. spaced single coil on mine provides a very good vape for me.
     

Share This Page