I built the 8 dollar mod box. Hated the gurgling and flooding of the atty. I had it like the original way high, a little high, real low, and flush. Each time I used it for at least a couple of days. For me the lower the better. Then I dremeled a tiny slot. This is awesome. Twice the vapor, and way easier to draw. And I haven't flooded it yet. Try it and let us know how it works for you.
510 connector tests
- Thread starter air1
- Start date
- th_trl_thread_readers 0
- Status
You mean you had the connector at different heights and then dremeled the connector? Or is this about a bottom fed mod?
Bottom feed mod. But applies to all. If bottom feed, keep the needle flush. Remove the center piece even if it's not a bottom feed. Then with a dremel thin cutoff stone cut a groove. Assemble, vape, enjoy, and report.
Ok the title says connector. But it's about the needle. The slot you cut in the needle then?
No. It's the center of the connector. If you happen to have a needle, run it flush.
Too much of a pain at the moment. Look at the battery side of a go-go and make it like that. It will draw much nicer, with much more thick dense vapor.
- Status
Similar threads
- Locked
