Ok guys .... this is what I got:
AGA T2
Kanthal 28
400 SS Mech
50/50 juice
Oxidize mesh
bottom cut diagonaly
7 wraps 1.1 ohms
No hot spot
Flavor is muted and my vapor production and th is really bad....
Second attempt and same thing.
I follow busardos tutorial and can not get it to works correctly.
What I'm doing wrong?
I am using a ATA-T2 right now filled with Boba's Bounty. The coil I have is 400 SS mesh at 2.1 ohms. On a VV/VW device It is set at 9W 4.34V and the flavor is amazing and the vapor production massive. I can put it on an ego twist and it performs just as well with starting with low voltage and increasing to find the sweet spot.
I know when I first got the AGA-T2 I had to play with the coils and for me personally found that 1.8 to 2.1 worked very well. As you know if you play with the coil you may get the "wandering ohm" syndrome. As far as the coil mesh I found that tightly wrapped mesh (no "straw" hole in the center) provided better capillary wicking to the coil. You might try tipping also to feed the juice if that is your problem.
My advice, at least what I did was experiment, build a few coils with different wraps and wrap techniques like free wrapping or using a drill bit, watch a lot of videos on coil building and have fun with it don't get discouraged. It is a great genesis style tank and you will succeed; and when you do the fun begins.
One video I highly recommend is
Z-Atty-Pro - Rebuildable Tank System V2.1. This is a step by step setup and even though it is a Z-ATTY Pro you can use the techniques on your AGA-T2.
Baditude's advice is right on the mark check out the referenced links.