The atomizer does come with a coil on the unit . Personally I would rap my own coil
An Affordable RBA, turn key & safe for our mods
- Thread starter redeyedancer
- Start date
- th_trl_thread_readers 0
- Status
I got enough posts just so i could post here and ask for pics of the internals and someone already did it oh well.I would just like confirmation on a couple points, the top cap is threaded correct? I hope so because i find the ERA cap far to hard to get off.the wider area between the posts should make doing mesh wicks much easier than the ERA as i was always bumping into the side wall with the ERA and shorting it out.throw me down for 2 of these my grands are lonely.
Rob never sets limits on purchasing quantitiesOne? One?? so there'll be a problem cuz I want more?!
Dang thats enough room to take 28-30awg wire and wrap enough coils to get over 2.0ohms
it means all ready to go just squonk it
Turn key means it is ready to use no modifications needed .plug and play
There is plenty of room for any type of coil you want to rap . The only down side to me with this atty is the small screws and the small holes to feed your wires through
lol yep I have a big magnifying glass Hello Tybinhands rob an old man magnifying glass
For sure I could build a much better atty it would cost more to as far as how they vape you couldn't tell the differenceI'd like that. AMERICN made baby!
I here that in my head often .I'd pay more, if you made it Rob. If you build it they will come
Build it they will come
I hear ya the atomizer is brass & nickel plated . I would go down the stainless road if I was doing it but we have all been using Chinese atomizers since we started vaping .sometimes lose little voices are legit
seriously, I'd trust the materials you would use any day over the Chinese
Lets not talk about my little voices
- Status
Similar threads
