Anyone running a Hana Modz V4S?

[Nuclear Cowboy]

If so what are your thoughts on this device? I've been thinking about getting one of the single battery "Limited Edition" ones in stainless steel.

I have a vaporshark rDNA40 now and love it. The chip is a perfect match for the type vaping I do.

The only thing that I don't like about it and most mods I've purchased in that it comes with a painted/coated aluminum case. I'm hard on my equipment and any coating on the case starts to look horrible in a very short length of time. My VS doesn't have any deep scratches in it but the paint is worn off on all of the corners and some areas of the flats and looks nasty. I was thinking with the bare stainless it could be refurbished from time to time with wet/dry paper and some buffing. I've tried wraps, skins and cases on other mods and simply don't like them.

It's expensive but after owning a lot of lower quality devices I don't mind paying a little more for American made quality but only if it's worth it. Alternatives, thoughts, opinions good and bad are invited!

This is the one I'm considering. It looks like it would be a tough one!

 

[LordMarv]

Nuclear...I have this mod, but in the cherry red. Ordered it directly from the Hana site. But I was thinking hard about this one...but all my mods are stainless steel and I wanted the red color. I really like mine. I don't bother with nickle wire, etc, just run it as a normal mod and it works like a champ. Love it. fits in my hand just perfect. Runs all my devices from carto tanks to sub-tanks. Don't have a scratch on it yet, but I baby it. A scratch would definately show on the red for sure. I would think if you did get minor scratches on the stainless, you might think about a jewelers cloth, much less abrasive. But no, not a single problem since I got it...it just works!