I maxed out with 28-24 claptons at 0.36ohms in order for it to work i had to clamp down on the leads and flatten or else the screws wouldn't pass without shorting. 7 wraps it vapes pretty good on my limited edition snow wolf 200w mod
Aromamizer RDTA by Steam Crave
- Thread starter roxynoodle
- Start date
- th_trl_thread_readers 0
- Status
It was 0.20 ohms after sorting out the hotspots. the ohms go up quickly while firing because it is a stainless steel coil.
Well, it happened... Finally had my Ah-Ha moment with this tank. took some 26g kanthal, wrapped it on a screw 7 wraps and mounted the coils. they were kinda inbetween the posts and almost touching each other so when I pulsed them so they were glowing I took a 5/32 drill bit and pulled them out to the edge of the juice well so the finished size was 5/32 spaced. wicked with KGD tails cut to just on the deck and fluffed out a bunch. Started looking at my juice and realized I was about out of my favorite strawberry milkshake so I made a new bottle of it and then filled this tank. Finally have good flavor coming out. Not sure what was going on, this build look an awful lot like all the rest i put in here that didnt have much flavor, but this one works well and tastes good.
Thanks for all the advise and for putting up with me.
Thanks for all the advise and for putting up with me.
The difference might be the inner diameter?Well, it happened... Finally had my Ah-Ha moment with this tank. took some 26g kanthal, wrapped it on a screw 7 wraps and mounted the coils. they were kinda inbetween the posts and almost touching each other so when I pulsed them so they were glowing I took a 5/32 drill bit and pulled them out to the edge of the juice well so the finished size was 5/32 spaced. wicked with KGD tails cut to just on the deck and fluffed out a bunch. Started looking at my juice and realized I was about out of my favorite strawberry milkshake so I made a new bottle of it and then filled this tank. Finally have good flavor coming out. Not sure what was going on, this build look an awful lot like all the rest i put in here that didnt have much flavor, but this one works well and tastes good.
Thanks for all the advise and for putting up with me.
I recall someone advising people using thinner wire to use smaller id.
well I have been all over 24g 26g 28g and 30G with inner diameters fro 2.5 to 3.5.... horizontal, vertical, wicked tight, wicked loose, long tails laying on the deck, medium tails just touching the deck, short tails dangling like my hopes and dreams above the deck. Twisted builds, clapton builds, single double and triple strand builds. stock driptip, no drip tip, different driptip. 4 air holes two air holes and no air holes opened. For the record that last one really didn't work at all.... no flavor OR vapor, just fyi. air holes centered on the middle of the coils, air holes at a 45 angle to the coils. Wicking inside the coil, wicking wrapped outside the coil, wicking left on the table instead of being installed with the coils. again, fyi, that last one dosent work at all.... it just leaks.
Im just glad it finally got sorted out!
Im just glad it finally got sorted out!
Today i was feeling some pain my chest and later when i changed the wick i found some plasticky piece on the top of the deck. The bottom part of this got burnt a bit but I have no idea how this went in or dont even know what it is as this clear red piece doesn't look familiar to me. I hope this wont happen to u guys and I hope I'm OK lol
BTW thanks for sharing many builds. I'm finally having a good vape out of this.
Sent from my SM-G925F using Tapatalk
holy cow! did something fall through the drip tip maybe? you didnt notice the taste at all? Glad you found it. hope you figure out what it was and above all avoid it in the future!!
Haven't seen anything going in through the drip tip and really have no clue how it went in. I didn't notice the weird taste or anything at all either. but lucky I wanted to rewick today lol
Sent from my SM-G925F using Tapatalk
That's exactly what I thought. I could have avoided this if I had the stock drip tip instead of no drip tip or maybe could have swallowed the entire piece stuck in the anti spitback lol
Thanks for the concern anyway!
Sent from my SM-G925F using Tapatalk
My biggest concern was sucking a mosquito through the airhole on my st mini in the summer but now you got me worried cause i vape without drip tip too. We need small umbrellas to cover the hole when the tank is resting i think. A whole new market awaits.
Im really sorry to post comments conteniously which isnt related directly to the tank. but lemme post the last one as I think I found what it was.
It was really hard when I picked it up from the deck, but now when I touched it again i found it really soft and smelled familiar. I'm guessing it's a piece of sweet potato. Yeah I know it sounds stupid but I believe that's a piece of baked sweet potato that I had in this afternoon... And I feel like I vaped between... I don't know why I still feel pain inside my chest but glad it wasn't as bad as plastic. Thanks for ur comments and concern guys. wipe ur mouth before u vape and don't vape while eating.
Sent from my SM-G925F using Tapatalk
It was really hard when I picked it up from the deck, but now when I touched it again i found it really soft and smelled familiar. I'm guessing it's a piece of sweet potato. Yeah I know it sounds stupid but I believe that's a piece of baked sweet potato that I had in this afternoon... And I feel like I vaped between... I don't know why I still feel pain inside my chest but glad it wasn't as bad as plastic. Thanks for ur comments and concern guys. wipe ur mouth before u vape and don't vape while eating.
Sent from my SM-G925F using Tapatalk
Sweet 'taters and marshmallows.. Just like Thanksgiving dinner.You sure you weren't trying to come up with a new juice flavor???
$9.22 DIY Authentic Steam Crave Aromamizer RDTA Replacement Deck - stainless steel / 2-post at FastTech - Worldwide Free Shipping
$2.96 Authentic Steam Crave Aromamizer RDTA Ni200 Coil Head - 0.15ohm at FastTech - Worldwide Free Shipping
$2.15 Authentic Steam Crave Aromamizer RDTA Replacement Glass Tank at FastTech - Worldwide Free Shipping
$2.96 Authentic Steam Crave Aromamizer RDTA Kanthal Coil Head - 0.3ohm(15-40W) / dual coils at FastTech - Worldwide Free Shipping
$2.96 Authentic Steam Crave Aromamizer RDTA Ni200 Coil Head - 0.15ohm at FastTech - Worldwide Free Shipping
$2.15 Authentic Steam Crave Aromamizer RDTA Replacement Glass Tank at FastTech - Worldwide Free Shipping
$2.96 Authentic Steam Crave Aromamizer RDTA Kanthal Coil Head - 0.3ohm(15-40W) / dual coils at FastTech - Worldwide Free Shipping
Last edited:
thanks for posting that dwcraig !$9.22 DIY Authentic Steam Crave Aromamizer RDTA Replacement Deck - stainless steel / 2-post at FastTech - Worldwide Free Shipping
$2.96 Authentic Steam Crave Aromamizer RDTA Ni200 Coil Head - 0.15ohm at FastTech - Worldwide Free Shipping
$2.15 Authentic Steam Crave Aromamizer RDTA Replacement Glass Tank at FastTech - Worldwide Free Shipping
$2.96 Authentic Steam Crave Aromamizer RDTA Kanthal Coil Head - 0.3ohm(15-40W) / dual coils at FastTech - Worldwide Free Shipping
just ordered from them yesterday and it was not there.
so I got one of the clones to find out if I can modify it.
should have waited ..one day . missed it by that much !!
- Status
