atty cleaning question - drying

[DcMagic]

I just soaked my atty in crest pro. And rinsed with warm water. Now I hear a lot of people say that they let them dry over night. I can't just blow it out and heat up the coil and puff on it a couple times without inhaleing to dry it? Or do you HAVE to let it dry over night? I just wanna speed up the drying process.

 

[Dkrom68]

I wouldnt recommend it cause it will usually short it out and deem it no good they really require a thorough drying. I dont know what you used to clean it but Crest Pro Helth mouthwash works the best. Let it soak for 20 to 30 minutes aggitating it often and rinse with water let soak overnight and blow out and let dry. makes them run alot better

 

[Marctwo]

I never let them dry. I just blow it out, dry the thread, prime it and use it.

This works fine for me but I can't recommend anyone else to do it... so don't blame me.

 

[doots]

I never dry completely. Like Marc said.

 

[athlon14]

I dry them in a 150 degree oven for an hour

 

[crashtestjeep]

use a balloon. inflate, put mouthpiece over atty ends, let air escape only thru atty hole while deflating balloon. voila,,dry as a bone in under a minute!

 

[jj2]

I got several I rotate so I clean and they have several days to dry.

 

[sjohnson]

I usually dry them, but gently blowing them out from the thread side, daubing the cart side with tissue, then priming with 4-5 drops juice does work for me.

The first few puffs are weak to non-existent as you vape the remaining water but then the juice kicks in.

 

[devonschmoker]

I shove my mine in the grill of my forced air wall heater. Then I pluck it from the grill using a pair of pliers. (as I can be impatient and that thing get hot.) This method takes about 10 min and your atomizer is bone dry.
A hair dryer works well too but it takes a lot of patients or desperation at it can take up to 30 min to dry.