Blew too hard on the atty?

[c0Ld]

I wanted to start using my new 510 atty and I remembered reading on the forum that you should blow on the threaded end to get out the primer fluid. So I wrapped my lips around the atty and blew as long as I could but now when I look inside the atty it looks like I might've blew out a material that got stuck under the metal coil/bridge thing. It looks somewhat cottonish and is somewhat small but still noticeable. Any ideas of what it might be? Is it bad that it's there? Also I screwed on the [manual] battery to the atty and held down the button for a few seconds to see if the atty was affected by the unknown object and it seemed to work as normal but after a couple seconds of holding it down the atty started glowing bright red, which I've never seen before when I tried it with my older atty. I took a few puffs and all seemed fine but I'm still really curious as to what the hell it is. Any ideas?

 

[Kewtsquirrel]

Theres a wicking material inside of the coil, thats what you're seeing. You're fine, everything is working as intended.