Thanks KTM, Laurie and otherguy. Appreciate the tips and help. Can't wait to get started. Should be fun!
Building a "hana" style mod with the fasttech enclosure: looking for tips, tricks, and suggestions
- Thread starter HOPS
- Start date
- th_trl_thread_readers 0
- Status
Off Topic but, I like Hana mods, But one 18650 is just not enough battery for me. So I built this..........
Nice but too big for me. I'm actually the opposite. What matters to me is size so as long that the mod is around 70mm tall and narrow enough to be concealed in one hand, I'm happy. Doesn't matter if it's a hana, clone or something entirely different 
Regards
Tony
Sent from my GT-I9195 through Tapatalk
Regards
Tony
Sent from my GT-I9195 through Tapatalk
The first mod to my mini was to replace the fake AW 18490 1100mah with a Turnigy 1200mah Lipo. I used Deans Micro Plugs. The battery sled came out easily but noticed before that it was made for a skinnier battery... like a AA battery 
I really wonder what these guys were thinking sometimes.
I used 18g wire with adhesive lined heat shrink tubing and 3M electrical tape to cover the ends. There's about a 6-8mm gap in the battery compartment so I had to put a couple of plastic washers to fill the gap so the batteries don't move around.
I really wonder what these guys were thinking sometimes. I used 18g wire with adhesive lined heat shrink tubing and 3M electrical tape to cover the ends. There's about a 6-8mm gap in the battery compartment so I had to put a couple of plastic washers to fill the gap so the batteries don't move around.
Last edited:
The first mod to my mini was to replace the fake AW 18490 1100mah with a Turnigy 1200mah Lipo. I used Deans Micro Plugs. The battery sled came out easily but noticed before that it was made for a skinnier battery... like a AA battery
I used 18g wire with adhesive lined heat shrink tubing and 3M electrical tape to cover the ends. There's about a 6-8mm gap in the battery compartment so I had to put a couple of plastic washers to fill the gap so the batteries don't move around.
I don't see the benefit. Did you do it just to add 100 mah?
That stuff seems pretty 'flexible' - any walkthroughs available?
what do you glue it with? er, do you glue it?
Hello everyone New to this thread and planning on embarking on my first DIY pretty soon, once i've assembled all that is needed and have done quite a bit of research taking in a lot of information. Have been trying to read up and catch up on this thread as well. Planning on starting off with a "hana" style enclosure with a few different changes of course. WOndering if there is anything i should know to make the project run smoother?
yeh - be more specific with your questions ;-)
only joshin - chaps here are all great when it comes to advice.
You doing a DNA 30 or 40?
Going with the Dna 40, ANd i will be as specific as possible if i do have any questions that arise.
- Status
Similar threads
