Hello,
I have been into vaping for 1 year now.
I have owned two iJust S's, a smok fit,
And now owning a smok Alien 220W kit with the
Geekvape Zeus dual RTA & an iJust with the DROP RDA, both
Running dual Alien claptons @ 0.21ohms.
This has been the dream setup I had been wishing for.
I have always liked the mech look, the small form factor
And also the huge vapor output.
So to get a similar experience, that's why I went for the iJust S + drop RDA,
but the power output is less than enough.
I have been thinking a lot about building a mech mod,
But the safety question always comes up first. Yes, I do understand
The ohm's law, battery safety etc., but so did my friend until his
Mech mod just popped on the table of his room.
Is my confidence on point and I should look forward on building a mechanical mod,
Or just stick to the regulated mods instead?
I have been into vaping for 1 year now.
I have owned two iJust S's, a smok fit,
And now owning a smok Alien 220W kit with the
Geekvape Zeus dual RTA & an iJust with the DROP RDA, both
Running dual Alien claptons @ 0.21ohms.
This has been the dream setup I had been wishing for.
I have always liked the mech look, the small form factor
And also the huge vapor output.
So to get a similar experience, that's why I went for the iJust S + drop RDA,
but the power output is less than enough.
I have been thinking a lot about building a mech mod,
But the safety question always comes up first. Yes, I do understand
The ohm's law, battery safety etc., but so did my friend until his
Mech mod just popped on the table of his room.
Is my confidence on point and I should look forward on building a mechanical mod,
Or just stick to the regulated mods instead?