Is Gregg tightening down the screws. Better yet does he even have the screws for his atty. I've read most of this and never heard anyone mention screws yet. Might have missed that part though
Is Greg a troll? I'm with you Rapture. I think the issue is that the coil is to low in resistance for the mod to read. A multi-meter would answer this question definitively. Use higher gauge Kanthal (i.e. 32g) to build a coil your mod can handle.
An ohm meter reads a more accurate resistance when I first started sub ohming I would check with my mvp v2 and once I got a 0.0 so I went to the shop bought an ohm meter and it was really a .3
I noticed that store bought ohm meters are pretty good but can give slightly inaccurate readings when compared to a good multimeter. This is especially important when sub-ohming. Plus, with a mutlimeter you can check your battery's voltage periodically (essentially removes any guess work). I have also gotten into the habit of checking battery voltage right off the charger and have discovered a few faulty chargers that over charge my batteries.
yes on goes through the center post, the other goes through a post on the side. it can be center post right or center post left.
is this right?
As for not wanting to die, sometimes I worry about the regulation of the ecig juice. hopefully there is some sort of regulated safety/contaminant check.
feels wierd seeing someone on here from oceanside. hopefully I don't piss him off and have him come after me. Heh, he probably sold me my ecig
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.