cart material??

Status
Not open for further replies.

ejoker

Vaping Master
ECF Veteran
Verified Member
Jan 15, 2010
6,586
844
looking for input as to cart material. was thinking of making a steel cart/filler for my 510s. the filler would perhaps have a small o-ring to ensure proper fitment and eliminate seeping. they'd be easier to clean as well, no warping or melting.
was also thinking perhaps a cap on the filler, with a fine flex mesh top, similar to the adm/zfm. pop the top to fill, replace and go ...

any drawbacks with a steel/metal cart that anyone can think of? or is this an already hashed out idea?
 

Scottbee

Vaping Master
ECF Veteran
Sep 18, 2009
3,610
41
Okauchee Lake, WI
It can certainly be done. As a matter of fact, almost the exact same configuration that you are contemplating has already been discussed, and partially fabricated.

If you're going to go with "steel", make very sure that you are using an austenitic stainless steel... 303, 304 or the like. Keep away from traditional carbon steels and martensitic stainlesses.
 
Status
Not open for further replies.

Users who are viewing this thread