daisy, I try to make sure that I am not 'strangleing' the juice from getting to the coil- BUT i do think you might be right. sometimes that does happen. and honestly, I have started sometimes leaving off the cup cap and just using the Oring. I didnt think about cutting them- mostly cause I dont do 'tedious' work well.. LOL
Kelly, I think i was getting a dry burn, most times if I got a dry burn and then would tip it upside down for a second or two, I could get an almost decent hit the next time.
SINCE my juices are all the same, thats why I was trying to blame some outside force. Like the fog or something. LOL
some of them were new, so no junked up coils, and I clean them pretty well - so .....
and I am thinking that the cup is a pITA, and the Oring is my best bet. it doesnt prevent leaking as well, but heck, something is better than nothing. LOL
Fixin to get ready to take my truck to the tire dealer- I thikn my tie rods are out- which is NOT good- I just pray my bearings and all that are still decent- I just put 2 notes into the durn thing for that EGR cooler thing!!