Chit Chattin away!

Status
Not open for further replies.

Lilacs212too

Ultra Member
ECF Veteran
Verified Member
Jan 20, 2010
1,661
450
48
Williamsburg, VA
there are just not enough bananas dancing to show my enthusiasm for vape mail today! Now.. to figure out how to fill this tank thing.. :D

IMAG0214.jpg
 

beebopnjazz

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 20, 2010
7,829
8,247
PA
:banana: Melly!

fill the cartomizer - (don't get that center tube!) / once that's done - with the cartomizer mostly but not all the way in- hold tank on a 45 degree angle and get your juice going down the inside of the tank - while it's filling - slowing right the tank - the juice will continue it's path down the side - once it's nearly to the top of the cartomizer push the cartomizer up all the way - making sure that the flanged bottom fits snug against the tank.

Place tank on a flat, hard surface - pushing down to make sure the carto is seated in the tank properly. Place on your new baby - then put the drip tip on. (putting the drip tip on first could cause you to push the cartomizer down and you would make a mess of your juice).
 

beebopnjazz

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 20, 2010
7,829
8,247
PA
That's a flange bottom -makes it easier to get them seated properly. Some use their own cartomizers - shorter - have to cut your tank down to accommodate and be careful when you have it in that it's not in too far or you'll leak. You also need to punch a hole in your own.

Lox purchased a drip tip/carto combo that was supposed to permit using the shorter cartomizers - but it wasn't quite the right fit either.

B knows how to make your cartos work in a tank - I believe she's done this before.
 

beebopnjazz

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 20, 2010
7,829
8,247
PA
Well, first never buy the ones with 3 holes - they gurgle and flood. 2 holes or 1 hole are fine.

I just bought a bunch from vaping zone for 1.69 each. (3.2 ohm) - I'm not a fan of dual coil - don't know if you are - I think those are 1.99 at VZ.

That's the best price I've seen. Provape's (3 ohm) are 2.99 each (single hole)

V4L carries them too - but usually only the 808 connection (2 hole) - with an adapter you're good - I have a few of those too from when they were having a tank sale (which is how I found out I didn't like dual coil) - they started carrying 2 ohm and 3 ohm. I have some.

What do you like your provari set at?
 
Last edited:

Lilacs212too

Ultra Member
ECF Veteran
Verified Member
Jan 20, 2010
1,661
450
48
Williamsburg, VA
if you don't want them, I would take them.. can we work out some kind of a trade? And Jazz.. not sure, really, I was borrowing one and generally had my 3ohm set at 4.1 -4.4 during the day but at night, I like it higher, and bump it up to 4.8 or 4.9.. I tend to crave more.. heat?.. at night I guess..
 

beebopnjazz

Vaping Master
Supporting Member
ECF Veteran
Verified Member
Jan 20, 2010
7,829
8,247
PA
I like the heat (unlike Lox) - but I wasn't happy with dual coil - I didn't have the provari at the time - it wouldn't work on some of my pvs so I had it on the turbo at 3.7 - wasn't impressed with the vapor at that rate. I find there are times I like it higher too - which is why I buy the 3 ohm single coils. :)
 

BiancaMontgomery

SQUIRREL!
Supporting Member
ECF Veteran
Verified Member
Jan 27, 2010
13,516
8,065
North Carolina
Dr. says....NO SURGERY :banana: *throws streamers, but only with good arm* Tendonitis and a tear, but he thinks a cortizone shot and some therapy will do wonders and I'm going to go with that cause that's exactly what I wanted to hear :laugh:. The inflamation is pushing on nerves and vessels and that's obviously why the whole arm/hand goes numb. The hand pain is the joint disease and I will just continue to take the high dose Motrin for that and get on with life. I get my shot on Thursday. Sooooo relieved, omg!
 

BiancaMontgomery

SQUIRREL!
Supporting Member
ECF Veteran
Verified Member
Jan 27, 2010
13,516
8,065
North Carolina
It's been an AWESOME DAY! Not only do I not have to have surgery :banana:, but I worked out a little somthin' with my girl Chips and THIS arrived today:
biancamontgomery-albums-more-stuff-picture98663-hog-mod-35-tess-canary-body-purpleheart-ends-inlay.jpg


Back to not having to worry about switching batts or refilling. This one also feeds so much easier than my #10 Hog did. Looks like the metal tube might be a little wider...which is good! Love it!
 

Darkwitless

Vaping Master
ECF Veteran
Verified Member
Aug 21, 2010
3,158
905
KY
Chelle - Promise me that after your cortisone shot you will strap that arm down tight and NOT move it or use it for the rest of the day and baby it the next? You don't want to use it because it works the cortisone out of the target area!!

My poor sister has had many shots - but it wasn't until 3 years ago her Dr told her to not move her ankle and stay off it for at least 24 hours. Explained why her shots didn't bring her much relief or the relief didn't last longer than a month!
 

pringles13

Vaping Master
ECF Veteran
Verified Member
Jul 30, 2011
4,994
6,819
jaw-juh
That is such a pretty Hog mod!! :) Glad she's going to someone who is gonna use the heck out of her. Bottom feeding just wasn't my thing, but I do want a non-feeder VV Hog. :D I just love Mike's wood :lol: (go ahead, put it in the dirty minds thread)

It's been an AWESOME DAY! Not only do I not have to have surgery :banana:, but I worked out a little somthin' with my girl Chips and THIS arrived today:
biancamontgomery-albums-more-stuff-picture98663-hog-mod-35-tess-canary-body-purpleheart-ends-inlay.jpg


Back to not having to worry about switching batts or refilling. This one also feeds so much easier than my #10 Hog did. Looks like the metal tube might be a little wider...which is good! Love it!
 
Status
Not open for further replies.

Users who are viewing this thread