I got my Dual coil cartomizer 510 about 2 weeks ago, I was excited to try my first one, but to my disappointment the vapor production is very weak. I already use 2 of the cartomizer and got the same result. Since then i went back to my Ce2 cartomizer and I already sent 2 tickets to madvapes and have yet to receive a reply which I find unusual because they always quick to answer my question. Anybody having the same issue? did i receive a bad batch?
- Status
What battery are you running them on?
And, I've had a few bad ones. Try another one. Quality Control on the dual coils is a little bit suspect, in my opinion. But, the good ones being so much better than any other carto that there's hardly a comparison makes them worth it to me anyway.
And, I've had a few bad ones. Try another one. Quality Control on the dual coils is a little bit suspect, in my opinion. But, the good ones being so much better than any other carto that there's hardly a comparison makes them worth it to me anyway.
I thought the same thing at first but they seem to need to break in.After a while they seem to be a lot better.I'm on the same one after a week and half on a maxi roughstack at 3.7v and it is still performing great.
They take a lot of liquid and sometimes 2 or 3 fills to get going.. You've got to get at least 30 drops into them before they even start to spin up.
hoog
hoog
I made sure there was enough juice in there, I added about 25 drops. I thought that wasn't enough so I added more and several times I overfilled it that juice starts to leak out of the bottom hole. I used the cartomizer for 2 days so it should be more enough to break it in. Today, I just tested the 2 cartomizer that I already used on my usb 5v passthrough and one of them is dead, the other one still vapes the same. I'm tempted to try the other dual cartomizer that i didn't use but I am running out e-juice and soon order more from you guys. Does the dual cartomizer have any issues on some usb passthrough? I have similar usb passthrough that you guys sell on your site.
They don't work on amp limited devices. Your USB passthrough with a wall wart can only provide 2 amps. If you're plugging it in to a computer, you might only be able to pull an amp and a quarter to an amp and a half. - 5 volts in to a circuit with 1.5 ohms of resistance = 3.33 amps of current draw.
So, your passthrough probably sees the dual coil as a short and shuts down.
So, your passthrough probably sees the dual coil as a short and shuts down.
- Status
Similar threads
- Locked
