again i bet you all are using the 2.4 to 2.6 ohm, wait until you use a proper ohm e2r4
E2 Revision 4 Cartomizer Discussion
- Thread starter guitardedmark
- Start date
- th_trl_thread_readers 0
- Status
E2 4 are available again at COV at this moment.
They are back in this morning at COV. I just checked my email and at 1107 central received notification they are available. Of course ordered some.
Alice
They are back in this morning at COV. I just checked my email and at 1107 central received notification they are available. Of course ordered some.
Alice
I just ordered from COV the 2.x ohm and the 3 ohm. I'm so excited.
Turbo, you are so very kind I was getting ready to PM you and accept but checked my email and found notice that e2r4 were available, probably for only a very short time. I ordered XL 2.x and XL 3 ohm. The email was time stamped today 1107.
Woooooo Hoooooo
Thanks All
I didn't boil but used water just under boiling, several flushes and soaks. After blow drying I put them in my rice filled container for a day to absorb more moisture out.
First few draws on XL flavor was improved but then it got bad again.
The regular, probably one of the "rodent urine" stiff wick, discolored, didn't improve at all.
I just ordered some from COV that became available sometime after 0730 today. Don't know how long they will be in stock according to what everyone is saying about them "flying out the door".
Alice
So with the order I received last week, some of my cartos have the usual mouthpiece, center ring and filler cap and some of them have a longer mouthpiece and no center ring? which one is the real r4 ?
I think this latest version are more tolerant of the thicker juices. The highest mix I use is 50/50 which I wasn't able to use in the previous versions but not having any issues now....I've also experienced less gunk buildup with the Flavourart flavorings...
r4 have the most rotten burnt taste. i may just go back to cartomizers with filler.
OK, Now that more US vendors are carrying them, and hoping that they aren't getting the rejects that e-liquid pawned off to the regular consumers, I will make a small blurp on my experience with the supposed final revision cartos.
NOTE: all based on out of box functionality using 70/30 PG/VG DIY mix light flavoring
I was testing out a kr808 xl CE2 3 ohm (on a Tornego) and for the couple of cartos that I already tested I can say it's a huge improvement over the POS that I got when these were first released.
I filled them for a few times with the syringe, then filled by taking all the grommets out ( harder to align the slots of the most inner one with the wick, but IS possible)
I don't get any leakage,, minimal out the airway passage through the connection with my mix.
vaping/wicking is good when full, but it dwindles down well before carto is empty ( to use as much of the liquid you will have to either vape or set down the device with a slight tilt)
I don't have an excited feeling with these, but I can see how some of the masses will like them, I also can't confirm if the experience will be consistent from carto to carto or from other model threaded cartos.
I wouldn't sway anyones decision on purchasing the product itself since in my opinion it isn't a total fail and at the same time not necessarily the Holy Grail.
I would say if you are going to purchase direct from China that second thought might be needed since CS with e-liquid isn't up to par with some of the other more respected shops the vaping community has dealt with.
Final rating if I had to give one 3.75 out of 5
LGD
NOTE: all based on out of box functionality using 70/30 PG/VG DIY mix light flavoring
I was testing out a kr808 xl CE2 3 ohm (on a Tornego) and for the couple of cartos that I already tested I can say it's a huge improvement over the POS that I got when these were first released.
I filled them for a few times with the syringe, then filled by taking all the grommets out ( harder to align the slots of the most inner one with the wick, but IS possible)
I don't get any leakage,, minimal out the airway passage through the connection with my mix.
vaping/wicking is good when full, but it dwindles down well before carto is empty ( to use as much of the liquid you will have to either vape or set down the device with a slight tilt)
I don't have an excited feeling with these, but I can see how some of the masses will like them, I also can't confirm if the experience will be consistent from carto to carto or from other model threaded cartos.
I wouldn't sway anyones decision on purchasing the product itself since in my opinion it isn't a total fail and at the same time not necessarily the Holy Grail.
I would say if you are going to purchase direct from China that second thought might be needed since CS with e-liquid isn't up to par with some of the other more respected shops the vaping community has dealt with.
Final rating if I had to give one 3.75 out of 5
LGD
OK, Now that more US vendors are carrying them, and hoping that they aren't getting the rejects that e-liquid pawned off to the regular consumers, I will make a small blurp on my experience with the supposed final revision cartos.
NOTE: all based on out of box functionality using 70/30 PG/VG DIY mix light flavoring
I was testing out a kr808 xl CE2 3 ohm (on a Tornego) and for the couple of cartos that I already tested I can say it's a huge improvement over the POS that I got when these were first released.
I filled them for a few times with the syringe, then filled by taking all the grommets out ( harder to align the slots of the most inner one with the wick, but IS possible)
I don't get any leakage,, minimal out the airway passage through the connection with my mix.
vaping/wicking is good when full, but it dwindles down well before carto is empty ( to use as much of the liquid you will have to either vape or set down the device with a slight tilt)
I don't have an excited feeling with these, but I can see how some of the masses will like them, I also can't confirm if the experience will be consistent from carto to carto or from other model threaded cartos.
I wouldn't sway anyones decision on purchasing the product itself since in my opinion it isn't a total fail and at the same time not necessarily the Holy Grail.
I would say if you are going to purchase direct from China that second thought might be needed since CS with e-liquid isn't up to par with some of the other more respected shops the vaping community has dealt with.
Final rating if I had to give one 3.75 out of 5
LGD
Thanks for the report LGD. A good number of the XL's have wicks that are too short. At least some of the ones with longer wicks will vape the reservoir dry from a vertical position. Those that do, seem to keep the wick wetter and produce a better vape. In my opinion, this is the greatest fault that I am finding with the R4's.
As things stand now, many XL's need to be topped off when the juice level is about 1/2 way down. If we have to do that, we may as well be refilling a more convenient regular length E2.
I'm in full agreement about dealing with more respected shops.
lol, that's a good point. Also hopefully the suppliers whose customer service will replace non r4's will let possible customers know n their websites etc.
Yeah the flavorart stuff gunks pretty quick, but I've been using 90% VG with a 10% distilled water thinner which has been working with modded E2s, but not out of the box stuff.
Last edited:
I get mine at COV (CloudsOfVapor.com)... but I didn't see an XL 510's listed... are they out already?
Probably so. I think they had a bunch of 3Ω versions that went pretty quick.
- Status
Similar threads
