I have two 1000mah Ego-T batteries that I purchased last week. Yesterday while vaping I noticed the LED at the button blinking multiple times when pressed on one of them. As I had been using it pretty heavily, I assumed that was a signal it was getting low and plugged into the screw in USB charger.
Several hours later, the light on the charger was still red. I disconnected it from the charger and replugged it. It immediately went red again. I thought it should have charged by this time, but moved it to the USB passthrough cable and left it on my computer all night. When I woke this morning the light at the passthrough port is still red. I did 5 click the battery off beforehand.
The battery still fires an atomizer, so it isn't fried. But I guess for some reason it isn't shutting down when charged. Is there anything I can do to reset the chip inside? Or will I just have to start timing my chages on it?
Thanks for any input you might offer.
Several hours later, the light on the charger was still red. I disconnected it from the charger and replugged it. It immediately went red again. I thought it should have charged by this time, but moved it to the USB passthrough cable and left it on my computer all night. When I woke this morning the light at the passthrough port is still red. I did 5 click the battery off beforehand.
The battery still fires an atomizer, so it isn't fried. But I guess for some reason it isn't shutting down when charged. Is there anything I can do to reset the chip inside? Or will I just have to start timing my chages on it?
Thanks for any input you might offer.