Fatty atty on your lp!

Status
Not open for further replies.

FACE MEAT

Ultra Member
ECF Veteran
Verified Member
Mar 1, 2013
2,276
4,815
44
Costa Mesa, CA
All of you LP Grand owners out there:

Let's see some pics of big ol' bottom-fed RDAs atop your Low-Profile REO Grand! If your atomizer didn't begin life as a bottom-feeder, explain how you modded it.

I'll start...

IGO-W. The positive post is press-fit, so I used a pair of needle nose pliers with electrical tape wrapped around the ends to extract the pin. I cut a channel down the length of the positive pin with a Dremel and cutting wheel. a 1-2mm channel is sufficient to allow easy squonking and draining. I found it helpful to mark the positive pin where it protrudes from the upper insulator and avoid cutting the channel much higher than that to avoid cutting through to the female threads.

OOS7HTtl.jpg
 

Dconnor

Ultra Member
ECF Veteran
Verified Member
Sep 10, 2013
1,057
2,511
Las Vegas
Where'd you get the 20mm Patriot clone?

I bought at Vapor Venue here in Vegas. I had only seen the 22mm before. I just looked and it is not listed on the website, but they had it in stock in the B&M about a month ago or so.
They also have on Fastech if you are not in any hurry.
 
Last edited:

B2L

Vaping Master
ECF Veteran
Verified Member
Jan 14, 2012
7,844
45,313
Jacksonville, FL
Last edited:
Status
Not open for further replies.

Users who are viewing this thread