All of you LP Grand owners out there:
Let's see some pics of big ol' bottom-fed RDAs atop your Low-Profile REO Grand! If your atomizer didn't begin life as a bottom-feeder, explain how you modded it.
I'll start...
IGO-W. The positive post is press-fit, so I used a pair of needle nose pliers with electrical tape wrapped around the ends to extract the pin. I cut a channel down the length of the positive pin with a Dremel and cutting wheel. a 1-2mm channel is sufficient to allow easy squonking and draining. I found it helpful to mark the positive pin where it protrudes from the upper insulator and avoid cutting the channel much higher than that to avoid cutting through to the female threads.
Let's see some pics of big ol' bottom-fed RDAs atop your Low-Profile REO Grand! If your atomizer didn't begin life as a bottom-feeder, explain how you modded it.
I'll start...
IGO-W. The positive post is press-fit, so I used a pair of needle nose pliers with electrical tape wrapped around the ends to extract the pin. I cut a channel down the length of the positive pin with a Dremel and cutting wheel. a 1-2mm channel is sufficient to allow easy squonking and draining. I found it helpful to mark the positive pin where it protrudes from the upper insulator and avoid cutting the channel much higher than that to avoid cutting through to the female threads.
