I'm summing it's comment about quality of description, what actually was discussed few posts back.
... my wish list is much too long. 
Once I rebuild it it should be just fine.You can definitely build an Aqua up to those numbers if you want, just remember it's a dual coil so you may need to use some 28 or 29 gauge wire to make your coils so they'll still fit. I used 32ga (all I had at the time) and ended up with a .5 ohm build. I don't really mind it, but like I mentioned at that low of a resistance it gives some of my juices a heavier throat hit than I prefer, which makes me cough, which gives me a headache.
I can give you some feedback on the Fogger once I get home (which is what I want to build first, anyway, since I've already heard a lot about the Taifun). Gotta wash it, build it, fill it, vape it, so it'll be a little while. Probably in around 4 hours or so. I didn't get it from Focal so I can't really say as far as quality will go, but from what all I have ordered from Focal already I've not had an issue with quality. Only ordered the Fogger from elsewhere so I could get it quicker since it was around the same price.
I have the Fogger V2 and V3 ... I don't have the newest Fogger V4, but based on the various feedback I have read over in the RBA section, like the previous versions the Foggers are only as good as Yiloong's ability to produce consistent batches without error. When the Fogger is properly machined piece for piece, its a very good RBA however, Yiloong is notorious for inconsistent build quality amongst their devices, one of the reasons that I am not a fan of Yiloong.
Air flow channels that are not fully machined, poor threading on the chimney, crooked top caps, glass tanks that do not stay in place unless they are taped down, and the list of manufacturing flaws goes on.
In addition to that, I don't care for their business practices, specifically mandating retails cost as a condition of supply to vendors. They are no where near the manufacturing quality leagues of Hcigar, Infinite, and EHpro, none of whom demand that their products be sold at a set price point as a condition of supply.
My Fogger V3 is good, in spite of a crooked fitting top cap, while my Fogger V2 is very disappointing because the air flow is blocked, and the stainless steel tank fits with the top cap like a pregnant women's belly due to poor machining. The Fogger V4's seem to have the same inconsistent build qualities .. some are machined perfectly, while some are not. So, Yiloong can't have my money until their manufacturing quality meets up with their Ego driven price demands.
But I do hope that you get a good one Skorpeyon.
finally got my Miraxus and my Omega RDA today (first order I ever placed from Focal). Got caught up in customs or something which is why I think it took so long. They shipped it out forever ago, so I don't blame them. 
... Think you can mod the Lotus in some way to keep it from moving around so easily? The Lotus and Maraxus make quite the pairing ... very medieval 
Vape mail!
I like the Miraxus a lot. Floating pin, magnetic button. Probably going to use it more with my Kayfun than with the lotus that's on it right now. I had to put that on there for my "Sonic Screwdriver" mod set. That's exactly what this pairing reminds me of.
The Omega is simple, as I expected. Going to build it later on but it's solid and fits together great. That's probably my biggest problem with the lotus. It has almost no friction between the base and the top so it comes right off or rotates at the slightest pressure.
I also picked up the Protank glass replacements and intend to put the pink one on it for my fiancé. I think she'll love it. They look good and were wrapped 3 times in bubble wrap so they made it to me without damage.
