The Line.
Line is a smallest genesis type atomizer. One version is made out of Stainless Steel and plexi ,
on that one you can see your liquid trough 3 windows and it has 2ml capacity tank.
2nd version is made out of Stainless Steel only and it has 2.6ml tank.
Holding capacity: 2ml and 2.6ml
Diameter: 14mm
Lenght: 55mm
Material: Stainless steel and full plexi
The wick hole 2.5mm
other holes are smaller - adjusted for insulating tubes
full plexi tube inside the SS body 10mm ID, 12mm OD.
How to make a setup for genesis Line? Follow this instructions by Rawveg and you can not go wrong.
You can of course experiment , but this is the best way.
If you want to use The Line on VV devices you can do it , but we do not recomend that.
Genesis system is made so you do not have to use VV. You set your resistance with kanthal wire.
Your resistance dependes on how much coils you make around SS mesh. We recomend 0,20 A1 kanthal
and 400# mesh , for example , 4 wraps of 0.20 kanthal will give you 1.8 Ohm.
Setup.
Mesh must not conduct electricity, it must be inert. It needs to be oxidized at all surfaces touching metal parts of atomizer or any part where we wrap our kanthal wire. It is best to oxidize the mesh along its entire length.
Burn your kanthal with the lighter. After burning with a lighter kanthal becomes softer, more pliable and this helps to get a tight fit to SS mesh when wrapping. This also helps to avoid the burning taste or glowing of kanthal wire..
Wrap the mesh around the 1.2mm thick needle or a nail, so you get the mesh tube. Mesh is rolled tightly onto the needle and then properly oxidized,
in order to avoid annealing of Kantal (red glowing) on your new setup, where the lower end of the coil is.
0. Cut your SS mesh 2.3mm x 3.7mm
1. tie the Kanthal to the lower electrode
2. tightly wrap Kantal around the mesh, so that you get 3 wraps on one side, and 4 wraps on the other side
3. wrap the end of the the wire onto the bigger electrode 3 times
4. and you will get a 1.8 Ohm setup
Line is using pure silver wire for electrodes. Silver is a best conductivity material and it is not toxic.
We try to avoid screws , so you do not have to carry a screwdriver with you. In V1 silver is a little soft ,
so in V2 we made it with hard silver wire. Thanks to our V1 users we made this change.
Electrical conductivity.
Filling the line is also very easy , fill hole is in the thread.
Use a bottle with a needle on it or syringe.
Where to buy mesh and kanthal wire.
Mesh 400#
Kanthal A1
