Goblin Mini RTA review.

[Two_Bears]

Oh man, thanks for the advice! I rewicked it a bit more loose and flavor has drastically improved. Extremely happy with the tank. Thanks again!

One more noob question... When wicked properly, should you see air bubbles come out from both sides of the wick? Right now I only see bubbles on one side after vaping it. TIA!

I don't sing the praises of a tank or atty to try to persuade people to buy something.

I said the GM had the best flavor of any RTA or tank I have ever used and tgat was my experienxe.

I LOVE THE GM and will use it till I strip the threads.

The farther the coils are from the mouth or too much cotton you really cut down the flavor

 

[Two_Bears]

With all my tanks it depends on which way the tank is leaning. Air travels up, so if it's tilted air will only travel through one hole but I've taken them apart before and both sides of the wick is wet so it must be drawing from both sides. Sometimes if your wicking is really had one side will dry burn, but it has to be noticeably different than the other. If it tastes burnt, or if brown juice is leaking out the wick hole after a new wick was installed then you know you have an issue.

You got it. Liquid always goes as low as it can vand air goes up. Lean the tank and all of the bubbles will come out the higher side.

 

[ThunderDan]

Oh man, thanks for the advice! I rewicked it a bit more loose and flavor has drastically improved. Extremely happy with the tank. Thanks again!

One more noob question... When wicked properly, should you see air bubbles come out from both sides of the wick? Right now I only see bubbles on one side after vaping it. TIA!

That is normal.

 

[davevape55]

Yep the single kanthal works just as good as dual, if not better. Somewhere between. . 8-1.0 ohms. I just recieved 3 clones from fastech all in different colors. They look good, however no spare tank seal for the glass. Anyone find parts for these?

 

[Two_Bears]

Yep the single kanthal works just as good as dual, if not better. Somewhere between. . 8-1.0 ohms. I just recieved 3 clones from fastech all in different colors. They look good, however no spare tank seal for the glass. Anyone find parts for these?

I LOVE single coils.

Will look around and see if they are available. If I stumble over spare screws I will let you know.

 

[milescadre]

Gotta say lovin the new mini. rockin a single 1 ohm coil and it outperforms even my goblin! tho I cant toss out the goblin, looks too dang sexy on that hammer ^^

 

[davevape55]

I'm sure my friend Greg knows where to get some. I was supposed to drive down to Walnut Creek last weekend but was sick. He's an old friend who has many contacts with machine shops,screw shops ect.

 

[Two_Bears]

Gotta say lovin the new mini. rockin a single 1 ohm coil and it outperforms even my goblin! tho I cant toss out the goblin, looks too dang sexy on that hammer ^^

Sounds like we have a new convert to the .8-1 ohm fan club Dave.

All in favor of our new member say Aye.

 

[Two_Bears]

Sounds like we have a new convert to the .8-1 ohm fan club Dave.

All in favor of our new member say Aye.

I use two tanks. the Goblin Mini rocking St .78 ohms.

The Kayfun Lite Plus with Bell cap rocking at .84 ohmd

 

[Ou2mame]

Gotta say lovin the new mini. rockin a single 1 ohm coil and it outperforms even my goblin! tho I cant toss out the goblin, looks too dang sexy on that hammer ^^

How's the mini look on the hammer? I've wanted to get a hammer for the past year. I saw the clones let you stack the battery under the 510? I feel like that would be perfectly compact.

 

[milescadre]

Sounds like we have a new convert to the .8-1 ohm fan club Dave.

All in favor of our new member say Aye.

Technically, my goblin is at .68 and my mini I redone to .52. But both coils technically are 1-ish ohms ^^ The single coil wasnt cutting it for me and I think it was shorting on the reducer (chinsey clones)

But I do rock my kayfuns with a 1.1 still.

How's the mini look on the hammer? I've wanted to get a hammer for the past year. I saw the clones let you stack the battery under the 510? I feel like that would be perfectly compact.

imo too short on the hammer. And the way the base slots doesnt look appealing with the top cap I put on (I frankenmodded my hammer with a king top cap and switch).

Should never stack batteries. However, the Wolf Hammer on fast tech is designed to house a 18650 and I'd bet the mini would work on that. Though I use efest purple 18350s and safely vape down to .5 coils (albeit with little battery life)

 

[BigGOOSE]

Sounds like we have a new convert to the .8-1 ohm fan club Dave.

All in favor of our new member say Aye.

Aye!


Sent from my iPhone using Tapatalk

 

[BigGOOSE]

Technically, my goblin is at .68 and my mini I redone to .52. But both coils technically are 1-ish ohms ^^ The single coil wasnt cutting it for me and I think it was shorting on the reducer (chinsey clones)

But I do rock my kayfuns with a 1.1 still.



imo too short on the hammer. And the way the base slots doesnt look appealing with the top cap I put on (I frankenmodded my hammer with a king top cap and switch).

Should never stack batteries. However, the Wolf Hammer on fast tech is designed to house a 18650 and I'd bet the mini would work on that. Though I use efest purple 18350s and safely vape down to .5 coils (albeit with little battery life)

I usually toss the gm in the nemesis 350 around bedtime its at .6 ohms using aw 350 800mah should I be concerned with safety then ?


Sent from my iPhone using Tapatalk

 

[milescadre]

if the info on them is correct and theyre 15c, they should have a 12 amp limit and should be safe at ,6 ohms with a 41% headroom (according to steam-engine)

I usually toss the gm in the nemesis 350 around bedtime its at .6 ohms using aw 350 800mah should I be concerned with safety then ?


Sent from my iPhone using Tapatalk

 

[BigGOOSE]

if the info on them is correct and theyre 15c, they should have a 12 amp limit and should be safe at ,6 ohms with a 41% headroom (according to steam-engine)

Never hurts to double check, thanks!


Sent from my iPhone using Tapatalk

 

[Two_Bears]

if the info on them is correct and theyre 15c, they should have a 12 amp limit and should be safe at ,6 ohms with a 41% headroom (according to steam-engine)

Just be careful brother. Battery venting can be scary.

 

[BigGOOSE]

Yea I've vented my first mech with a tank when I first got into vaping tossed a nautilus in a hybrid got warm and chucked it. Nothing exciting but made me do some research. I figured I was safe just like reassuring myself. Lots of knowledgable people in this forum never can be too safe !


Sent from my iPhone using Tapatalk

 

[Two_Bears]

Yea I've vented my first mech with a tank when I first got into vaping tossed a nautilus in a hybrid got warm and chucked it. Nothing exciting but made me do some research. I figured I was safe just like reassuring myself. Lots of knowledgable people in this forum never can be too safe !


Sent from my iPhone using Tapatalk

Grimmgreen accidentally put batteries in series when they were supposed to be parallel and he destroyed a two 18650 battery mod on camera and destroyed the batteries and destroyed a $150 mod on camera.

All I am suggesting is be careful where batteries are concerned

 

[Ou2mame]

imo too short on the hammer. And the way the base slots doesnt look appealing with the top cap I put on (I frankenmodded my hammer with a king top cap and switch).

Should never stack batteries. However, the Wolf Hammer on fast tech is designed to house a 18650 and I'd bet the mini would work on that. Though I use efest purple 18350s and safely vape down to .5 coils (albeit with little battery life)

Oh I didn't mean using more than one battery, I meant that with the authentic, I believe you can only put the battery under the power button, but on the clones you can put it under the 510 so it's not an L shape

 

[BigGOOSE]

Grimmgreen accidentally put batteries in series when they were supposed to be parallel and he destroyed a two 18650 battery mod on camera and destroyed the batteries and destroyed a $150 mod on camera.

All I am suggesting is be careful where batteries are concerned

Appreciate the concern. Do you remember what video it was?


Sent from my iPhone using Tapatalk