HEX screwdrivers for SMOK MAG and G Priv MODs

[kisianik]

HI
Those 2 mods crapped out on me, most likely broken connection of some kind, as both can not read attached tank.
Planning to pull apart and do my best to find the issue, but I realized that smok is uses HEX type screws and I need those screwdrivers.
I wonder if someone here knows something about those sizes, as they are very small - I tried my professional Dewalt bits, but they are too big, so I need tiny ones.

Any ideas appreciated.

 

[puffon]

Are you sure they are Hex or Torx (star shape) bottom pic

Torx bit set are available at hardware stores, Home Depot etc.
#4 and #5 Torx are common sizes for mods

 

[GOMuniEsq]

Smok's reputation is among the lowest because their products tend to crap out sooner than you'd reasonably expect.

 

[kisianik]

Thanks a bunch.
Torx is what I need and thanks for sizes.
My G Priv crapped out after serious physical damage (I got into car accident, cracked my ribs, MOD flew from the seat to the foot part and fall apart a bit). It worked after accident for a few months and finally died. My second accident vape was Aegis, I think it bent my car.
MAG was given to me by friend who gave it up.
I was building computers before, I think I can handle this task as well.
Thanks again for pointing me into the right direction.

 

[puffon]

Thanks a bunch.
Torx is what I need and thanks for sizes.
My G Priv crapped out after serious physical damage (I got into car accident, cracked my ribs, MOD flew from the seat to the foot part and fall apart a bit). It worked after accident for a few months and finally died. My second accident vape was Aegis, I think it bent my car.
MAG was given to me by friend who gave it up.
I was building computers before, I think I can handle this task as well.
Thanks again for pointing me into the right direction.

This is the set I got.
Not the best quality, but will work for occasional use:
Husky 8-in-1 Precision Torx Screwdriver Set-70381H - The Home Depot
Stay safe!