prob is I cant find a small enough on/off switch that will hold up to these batts that aren't huge.
and made up a drawing for the VV chip, going to wire one up tomorrow and try it out. I don't want to send out a vv chip that can over drain the imr batts or just rely on protected batts protection circuit to shut the mod down.
I try to stay out of the modders forums since I became a supplier so its trial and error...
I think this should do what I want it to and prevent the mod from firing if the batts get down to 3.4v.
Everything I learned about this chip came from
http://www.e-cigarette-forum.com/forum/modders-forum/191607-easy-okr-t-vv-mod.html
and made up a drawing for the VV chip, going to wire one up tomorrow and try it out. I don't want to send out a vv chip that can over drain the imr batts or just rely on protected batts protection circuit to shut the mod down.
I try to stay out of the modders forums since I became a supplier so its trial and error...
I think this should do what I want it to and prevent the mod from firing if the batts get down to 3.4v.
Everything I learned about this chip came from
http://www.e-cigarette-forum.com/forum/modders-forum/191607-easy-okr-t-vv-mod.html
Last edited:
