How to Setup

Status
Not open for further replies.
Alright so i did as told and ordered the Vivi Nova, Provari v2 and some drops from pinkspot

So the vivi nova came in yesterday and the provari and drops should be coming in tomorrow, so i just wanted to know if there is anything special i need to do to set up my vivi nova, like priming or cutting the wic down a little
 

LifeLongJoyRide

Super Member
ECF Veteran
Verified Member
Feb 19, 2009
432
943
Austin TX
As long as the wicks aren't long enough to stop the tube from threading onto the bottom cap, you are fine. Whenever you use a new head, it's best to let the juice sit in the tank for at least a half hour or so to get a good initial wick. Wouldn't hurt anything if you did it now. One less to stop you from trying out your new toys that much sooner.
 

SurReality89

Senior Member
ECF Veteran
Jul 22, 2012
95
6
USA
i just put a couple drops directly on the coil, you can do this by just dropping it in the drip tip (hence "drip tip") but i just dropped it directly on the coil as i was filling it with the top part screwed off. i waited a couple minutes just to be safe but honestly i'm sure you could get a good hit right away after all if you drip it directly on the coil its obviously not going to be dry.
 

mostapha

Ultra Member
ECF Veteran
Verified Member
Jun 26, 2012
1,228
664
Atlanta, GA
I really think the vivi nova needs to be cleaned straight out of the box. I have 4 of them (had 5; I dropped my mini and it broke) and they all get rinsed and dry burned (this method), and rinsed again before they see juice. It takes the break-in time down to zero.

So, IMO, clean the head you're going to use (on a Provari, it doesn't matter…the voltage you set will just be different for each of them) as above, fill it, set the Provari fairly low, and start vaping……then turn it up 'till it tastes right.
 

tj99959

ECF Guru
ECF Veteran
  • Aug 13, 2011
    15,118
    39,615
    utah
    unfortunately my new drops arnt here and I want to use them on this beast. So I cant just put the drips in crank it to 5v and be on my marry way?

    Your Nova has a "top coil" atomizer, and top coils run hotter than bottom coils like what is in a normal atomizer/cartomizer. If you ran your brammy new Provari up to 5v with your Vivi Nova on it, you are in for one hell of a surprise!
    Can i suggest you set it at about 3.4v and slowly work your way up?

    Also where can i get the provari batteries and charger for a pretty decent price and shipping time?

    DON'T scrimp on batteries and chargers! Only use quality batteries and chargers purchesed from trusted suppliers.
     
    Last edited:
    Status
    Not open for further replies.

    Users who are viewing this thread