I'm not absolutely certain so don't quote me on this, but I think a 1.5 ohm dual coil amounts to the same resistance as a single coil 3 ohm so it would be a good substitute.
Thanks for the link!
I haz a sad
- Thread starter EvilZoe
- Start date
- th_trl_thread_readers 0
- Status
Thanks for the link!
Not really the same at all. If you're used to 3 ohm, going to 1.5 dual is quite a jump.
I was thinking she meant something different. Dual coil 1.5 would be 2 - 3 ohm coils. But yes, performance would be vastly different.
I agree cartos in general seem to be harder to find. Many stores I've been to that are still new tell me such things as "we've been open 2 months and you are the first to ask about those things" referring to pre-punched cartos.
I'm not sure I meant something different or not. I could have just been misinformed.
I also find it ironic that my statement "don't quote me on this" has been quoted repeatedly on this thread...LOL
Last edited:
I thought about that even as I was quoting you. Had to do it to get my meaning out I guess.
By the way, has anyone else noticed some of the newer bottom coil heads (kanger and aspire) seem almost designed after punched cartos? I have yet to put them to the test to see if they can hold up in hot weather, which is why I went to them over bottom coil designs. Evods were nice but flooded in heat so I found out carto-tanks are better for flavor as well as in the heat.
YES! ^^^THIS!
The bottom coils are fine and dandy unless you pull too hard or get accidentally leave them in the car for 5 minutes. At that point you're slurping rather than vaping and it's annoying, not to mention those clearos tend to leak.
I have yet to have a cartotank leak from not sitting upright.
I think I couldn't decide on that one because the length of the cartos weren't specified. That's sort of an important thing.
I may have been the victim of a bad production run, but I was not pleased with the 5 pack I purchased as an experiment.
I have never ordered from Fasttech and I'm not likely to start now.I may have been the victim of a bad production run, but I was not pleased with the 5 pack I purchased as an experiment.
I'm not good in the patience department.
Then you can only imagine what people think of me dripping on my 510 atomizers.
I still do, too!
Sent from my KFOT using Tapatalk
If you get desperate/run low before you can find a supply of standard, flanged, 3ohms -
you could get some XL to tide you over - they still work in a standard tank - a drip tip like ibtanked's tank
tool drip tips would work & and they have some that have a recess to allow space for carto that might stick up a bit.
https://www.ibtanked.com/accessories/drip-tips/ibtipsy
I reorder when I get down to one box left.
you could get some XL to tide you over - they still work in a standard tank - a drip tip like ibtanked's tank
tool drip tips would work & and they have some that have a recess to allow space for carto that might stick up a bit.
https://www.ibtanked.com/accessories/drip-tips/ibtipsy
I reorder when I get down to one box left.
- Status
Similar threads
