Wow i have a problem and need some help yall. Was running great tll brunt hit city. At 7w!!!!! Took it apart put on kbox and its not even glowing at 7 watts, put it back on ipvd2 and its red hot in under 1sec. All leads and screws are tight . I think my ivpd2 might be dead? and its new? UUGGGHHHHH
Indulgence Mt-Rta
- Thread starter 98ruby
- Start date
- th_trl_thread_readers 0
- Status
ok I dont understand. cleaned all leads, still doing the same thing. Kbox not even glowing coils....ipvd2 red hot in much less than a second. I have been vaping from 2012 and have never seen anything like this and the fact is that if something is wrong i can always fix it. But right now i am clueless.
As far as I know, all but the latest firmware revision of the IPVD2 do not have buck circuit which works in Wattage mode, so unless you have the latest firmware Rev 3.4 its probably dumping whatever your battery voltage is to your coils.
But it was working great. How do i tell if i have the FW you are talking about? Thanks And that looks like what it is doing.but was dong fine for a tank.
I had a mod that went haywire the first few days I had it. It was sending a lot more than the battery's voltage to the coils. I don't remember how much, but it wasn't usable. I returned it.
S%#t but this is a new ipvd2. Been going great till now......
Mine was new, too. I had it like 4 days. Contact the vendor. I wouldn't use it again. It could set on fire or something.
It shouldn't make it glow but the IPV doesn't have step down voltage (buck) in power mode. It's noticeable when running it that low to someone not used to higher watts. Your 7w would be like a 20w vape. However, it wouldn't make it glow.
any watts from 7-75 it does the same thing. Had it for a few months now so sure i will have to eat this one. Not sure that i will ever go back here once more.Will recoil tomm but i know its not that.....
Seems like sometimes mods have a glitch in them! My first IPV4 (yes no s) freaked out and started doing some kind of variable Ohm thing and finally quit. And as the curious male primate I am I took it apart & broke the seal which ruined the warranty! If it' really new FIGHT THE URGE!
Sorry for your troubles man. If you need a back up to get you by, I can let you use my K-box mini.
Thank you but i do have a kbox but it wont do .2 ohms. I think i found my answer to the ipvd2. "The D2 won't output less voltage than the battery has available. It will amplify the voltage, but it won't "step down" the voltage. So it won't output less than roughly 3.5 - 4.2 depending on how charged up the battery is." I am still looking into this and trying to see if they changed this with what version i have. But I dont know how to tell what version I have. Anyone know how to tell what version a ipvd2 is? Thanks
- Status
