Is there a guide to what voltage is best with what resistant coils???

[Garemlin]

Just got my spinner today and was playing around with it. Was trying different settings and used one of my X2 clearos and pretty sure I fried it by going too high. Getting nothing out of it now. Not that it was a great loss as that one always had a funny taste anyway. So is there a guide or standard as to what voltage goes best with different resistant coils. Right now I have it at a little above 3.8v and it is working great on my X2 clearos, mini T3 and Liquimax clearos. Tried the lowest setting and can't see where it would be beneficial for much. I just don't want to go too high on anything and end up frying another.

 

[Nukified]

I've been following this handy chart: http://www.statewidelegal.com/VapingPowerChart.png

 

[charlzrocks]

I've been following this handy chart: http://www.statewidelegal.com/VapingPowerChart.png

Awesome chart! Thanks for the great info!

 

[Thin]

Start off at low volts and increase slowly until it tastes good to you (other people's taste can be different). If it tastes burnt it's too high, and if there's no vapor/throat hit/taste then it's too low.

 

[Garemlin]

Good chart but seems weird that the X2 clearo is rated at 2.6 -2.9 ohms but when I set the spinner at a little under 4.3v it burned it out. Looks like I may keep mine at a click above 3.8v because it seems like a sweet spot for all the flavors I have tried to far. Great vapor and decent flavor. What are the T3 heads rated at???

 

[Nukified]

I think everything from SI is suggested to be used at 3.8v or lower. I try to stay on the left side of the green in the chart anyway to be safe.

 

[Garemlin]

I think everything from SI is suggested to be used at 3.8v or lower. I try to stay on the left side of the green in the chart anyway to be safe.

Yeah know but I pushed the envelope a little. Once too much. Everything else seems to be working fine on what I would way is right around 4.0v. No burnt taste. Great vape and consistant flavor.

 

[Garemlin]

Looking at the chart it looks like most of what I use is in the "just right" range for 3.3 to the 4.5 range. Don't think I want to push it to 4.5 though. How much past the 3.8 mark would you say is 4.0v???? Right now I have it about 1/16" past the 3.8 mark.

And one more question. Is it better to stay with lower or higher resistant coils. One company sells 2.2-2.4 and a 2.6-2.8.

 

[Nukified]

Slightly left of the middle point between 3.8 and 4.3 which is 4.05.

 

[Garemlin]

Slightly left of the middle point between 3.8 and 4.3 which is 4.05.

Almost afraid to crank it up that high. So where I have it set now isn't really any higher than 3.8v.

 

[JessicaS]

Halo has low resistance cartos that I think are around 2.0 ohms which would allow you to crank it up past 4.