Is there a guide to what voltage is best with what resistant coils???

Status
Not open for further replies.

Garemlin

Ultra Member
ECF Veteran
Verified Member
Mar 15, 2013
2,445
2,547
56
In the Mist
Just got my spinner today and was playing around with it. Was trying different settings and used one of my X2 clearos and pretty sure I fried it by going too high. Getting nothing out of it now. Not that it was a great loss as that one always had a funny taste anyway. So is there a guide or standard as to what voltage goes best with different resistant coils. Right now I have it at a little above 3.8v and it is working great on my X2 clearos, mini T3 and Liquimax clearos. Tried the lowest setting and can't see where it would be beneficial for much. I just don't want to go too high on anything and end up frying another.
 

Garemlin

Ultra Member
ECF Veteran
Verified Member
Mar 15, 2013
2,445
2,547
56
In the Mist
Good chart but seems weird that the X2 clearo is rated at 2.6 -2.9 ohms but when I set the spinner at a little under 4.3v it burned it out. Looks like I may keep mine at a click above 3.8v because it seems like a sweet spot for all the flavors I have tried to far. Great vapor and decent flavor. What are the T3 heads rated at???
 

Garemlin

Ultra Member
ECF Veteran
Verified Member
Mar 15, 2013
2,445
2,547
56
In the Mist
I think everything from SI is suggested to be used at 3.8v or lower. I try to stay on the left side of the green in the chart anyway to be safe.


Yeah know but I pushed the envelope a little. Once too much. Everything else seems to be working fine on what I would way is right around 4.0v. No burnt taste. Great vape and consistant flavor.
 

Garemlin

Ultra Member
ECF Veteran
Verified Member
Mar 15, 2013
2,445
2,547
56
In the Mist
Looking at the chart it looks like most of what I use is in the "just right" range for 3.3 to the 4.5 range. Don't think I want to push it to 4.5 though. How much past the 3.8 mark would you say is 4.0v???? Right now I have it about 1/16" past the 3.8 mark.

And one more question. Is it better to stay with lower or higher resistant coils. One company sells 2.2-2.4 and a 2.6-2.8.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread