Hello fellow vapers 
New around these parts, only been vaping for about a week. I am using a Sentinel M16 Mech Mod, with a Patriot MDA, with Efest 18650 battery (2500 mAh, 35A). But enough about me, jumping right into it!
I was watching some of RiP Trippers vids on youtube, learning about the basic coil setups when I ran across iTeo's Nano Dragon. I didn't have anything the right size to make nano coils, but I did have a large safety pin (.7mm). So I grabbed some 30ga Kanthol, wrapped it 20 times. Angled them right, ran my cotton wicks under and back over, blocked off the bottom end of the coils, left the inner/upper end open. I'm juicing a 60vg/40pg by Cali Joint Venture. I'm getting some pretty good vape, but it's not like some of the things I've seen off of this coil setup. I have links to the pictures, but as this is my first post, I cannot have them in here. I can upload them via this server if that is alright?
New around these parts, only been vaping for about a week. I am using a Sentinel M16 Mech Mod, with a Patriot MDA, with Efest 18650 battery (2500 mAh, 35A). But enough about me, jumping right into it!
I was watching some of RiP Trippers vids on youtube, learning about the basic coil setups when I ran across iTeo's Nano Dragon. I didn't have anything the right size to make nano coils, but I did have a large safety pin (.7mm). So I grabbed some 30ga Kanthol, wrapped it 20 times. Angled them right, ran my cotton wicks under and back over, blocked off the bottom end of the coils, left the inner/upper end open. I'm juicing a 60vg/40pg by Cali Joint Venture. I'm getting some pretty good vape, but it's not like some of the things I've seen off of this coil setup. I have links to the pictures, but as this is my first post, I cannot have them in here. I can upload them via this server if that is alright?
