The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Jemit Assets V3 Deck Question

Discussion in 'General Vaping Discussion' started by WharfRat1976, Jun 23, 2014.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. WharfRat1976

    WharfRat1976 Vaping Master Verified Member ECF Veteran

    May 31, 2014
    Austin, Texas
    Finally figured out ss500 mesh! I used a piece small enough that only required maybe 3 wraps around a 5/64 drill about 3/4" wide or less. Made a nice straw, torched it once, liquid burned it 3xs then put a little cotton on top and voila...great taste and wicking well with no tilting reqd. Here is my question. The negative posts have a screw AND a nut. Do I need a mini wrench to sandwich the negative lead between the screw and the nut, tighten then screw the assembly to the deck? For this build I just put the negative lead under the whole assembly and works fine but would be easier if I could set the negative lead "higher."
Thread Status:
Not open for further replies.

Share This Page