JonboyUSMC's Lava Tanks

Status
Not open for further replies.

debb

ECF Guru
ECF Veteran
Verified Member
Aug 12, 2010
10,930
8,261
in the nj woods
1zps0gy.gif
 

charmed412

Vaping Master
ECF Veteran
Verified Member
Oct 5, 2010
3,091
7,237
constant state of confusion
While I think yesterday may have contributed to the issue, I believe the list is the problem. If they were talking about the chit chat, they would have to deal with every supplier in here because there is chit chat all over all of them. While you are helping others and Jon....someone will always find something to complain about. :glare:

and Good Morning my lavacorps family!
 

debb

ECF Guru
ECF Veteran
Verified Member
Aug 12, 2010
10,930
8,261
in the nj woods
just a thought...about dry hits...my carto wasn't wicking properly every time...just a fluke..no worries...so I lifted the top cap ever so slightly and could see the juice going into the carto...problem solved...great hits so far...the carto was a punched one..I prefer the slotted...but I broke my slotting wheel to my dremel...:(
 

tyleris12

ECF Guru
ECF Veteran
Verified Member
May 23, 2010
10,367
15,820
Michigan
While I think yesterday may have contributed to the issue, I believe the list is the problem. If they were talking about the chit chat, they would have to deal with every supplier in here because there is chit chat all over all of them. While you are helping others and Jon....someone will always find something to complain about. :glare:

and Good Morning my lavacorps family!

Morning Charmed!:)
 

Joanr

Ultra Member
ECF Veteran
Apr 2, 2011
1,671
1,196
Colorado Springs
Good Morning all, guess I have missed a lot, not really been on for a couple days. Hope it all gets worked out okay. Is everyone well again?

Morning Linda, peeps are getting better slowly, we have a few new teaser samples that Jon posted last night, it's quiet in here today.
 

mwa102464

Resting In Peace
ECF Veteran
Oct 14, 2009
14,447
12,564
Outside of the Philadelphia Burbs, NJ & Fla
just a thought...about dry hits...my carto wasn't wicking properly every time...just a fluke..no worries...so I lifted the top cap ever so slightly and could see the juice going into the carto...problem solved...great hits so far...the carto was a punched one..I prefer the slotted...but I broke my slotting wheel to my dremel...:(

Lifting that top cap is a great way to prime the carto up if dry, try 2 holes Debb, seems to work much better than one hole, unless your using all PG.
 
Status
Not open for further replies.

Users who are viewing this thread