I should think it'll fire much higher than 1.0, but I never checked.
Hope so... I've got a pack of the 1.5 Claptons to try after this rba's installed coil.
Joyetech Ego AIO
- Thread starter jseah
- Start date
- th_trl_thread_readers 0
- Status
I should think it'll fire much higher than 1.0, but I never checked.
Hope so... I've got a pack of the 1.5 Claptons to try after this rba's installed coil.
I almost got the 1.5 coils and the Cubis tank just in case it wouldn't work in the ego, but decided didn't want to spend all that just for trying to get my ego to work. So bummed now to have to wait until next week sometime to try it again. I usually don't care for lower coils because I tried the 1.2 coil on my Nautilus mini and it was way to hot, thinking just not good for the mini because of the airflow.
Well I've given up on horizontal coils in the RBA. Last night I built a 3mm .6 ohm coil with 26g SS. This time I raised it a bit higher hoping the airflow would hit the coil still using just the insulator and not the screw, it seems to short and strip easily. Very low vapor and it starts burning the cotton after a few hits. So I'll take my chances with the vertical, the one that came with it is still in good condition. Eventually I'll experiment with different coil sizes and whether or not the screw is needed for it. Still a great vape when the RBA is working good.
I used the screw, need good connections for TC vaping. This works for me.
24 gauge titanium, 6 wraps on 3mm rod, approx. .20 ohms. KGD cotton. On most of my tanks and mods with similar builds I find I run mods at approx. 35 watts, and around 470F. Next build I will switch the cotton to rayon, to get the most flavor possible. Don't like the vertical build, changing just the wick only, far too much work to me. Good luck!
I agree vertical builds are a pain. The AIO doesn't use TC so I assume you are building for the Cubis therefore using the spare shaft and getting decent airflow.
Does anyone know if the pass through capability on the AIO completely bypasses the battery output? Or does it just support vaping from the battery while continuously charging?
I am pretty sure it is like all the others, charging circuit wired to battery, so "pass through" is actually drawing off of the battery.
I see..if that's the case then it'd probably be better not to use the pass through too often. Thanks sir
they are cheap enough to get two, so you can vape one while the other is charging
I clean it out the same way I clean out my eGrip tank. I recommend taping over the charging port to prevent water from going inside of it. Easy way to cover it up and remove after you're done.
True, but I was thinking of using the money to upgrade to the evic minithey are cheap enough to get two, so you can vape one while the other is charging
I have some Clapton coils coming in today that I will be trying with the AIO. Also have some 1.0 SS coming this week. I'm pretty sure I burnt my coils that came with the kit with my 70/30pg juice and air wide open with big tokes. I took a small bottle and put half my juice, and half PG to thin it out to try. I just want to get the thing going and see if I like it. Anyone know what my tester juice ratio is now? For the life of me I just can't figure it out.
I'm going to keep using it for the day and if it holds up well I'll be buying another. The stealth is just to good and getting some awesome vapor with it.
How does it compare to the SS coils in terms of flavor and vapor production? Does it have a tight draw to it? Hopefully it it being only 1.5 the coils will last longer and won't drink up too much juice
- Status
