I wanted a brushed stainless steel batt, but V4L don't carry them. I also wanted a stealth looking ecig.
As I have a bad battery (it works but you have to mess with the button and doesn't last very long) I decided to mod it.
Used my dremel and with a sand paper buffing wheel, I removed the paint around the button. Put the batt on a drill and put sandpaper on the batt and while spinning the batt I was holding the paper. One side done, I switched sized on the batt and did the rest.
Removed the cap over the green led and replaced it with the tip of a cheap ball pen. I placed some tape on the edge of the tip so I would get a snug fit.
I used the clip from a cheap screwdriver, bent the clip so it wouldn't put pressure on the button.
And Voila stealth vapin!
I will probably do it again on my good manual.
As I have a bad battery (it works but you have to mess with the button and doesn't last very long) I decided to mod it.
Used my dremel and with a sand paper buffing wheel, I removed the paint around the button. Put the batt on a drill and put sandpaper on the batt and while spinning the batt I was holding the paper. One side done, I switched sized on the batt and did the rest.
Removed the cap over the green led and replaced it with the tip of a cheap ball pen. I placed some tape on the edge of the tip so I would get a snug fit.
I used the clip from a cheap screwdriver, bent the clip so it wouldn't put pressure on the button.
And Voila stealth vapin!
I will probably do it again on my good manual.
My only question is what are you going to do when some one wants to borrow your pen?
