I've been doing just the opposite. My Minifit (my fingers want to type it as Misfit) will arrive today, but I have other pod systems already. And I have been using my squonkers less and less and my pods more and more. Been thinking about doing a high ohm build to see if I can duplicate the flavor from my pods.
Justfog Minifit
- Thread starter cardsfan300
- Start date
- th_trl_thread_readers 0
-
- Tags
- justfog
- Retails for
- 36
- Status
I've been doing just the opposite. My Minifit (my fingers want to type it as Misfit) will arrive today, but I have other pod systems already. And I have been using my squonkers less and less and my pods more and more. Been thinking about doing a high ohm build to see if I can duplicate the flavor from my pods.
Still working perfect this morning. Amazes me every time I pick it up! Flavor is fine but I would also like to increase the throat hit a little. Maybe I will try 12mg or so. It's almost like this thing manufactures juice lol. I think it's still half full. Would appreciate a pic of your diy sheath. Of course I would send any royalties required lol.
I got it charged and put in my 70VG ADV juice and waited about 20 minutes. I heard others say it is really airy (and I like airy MTL). So I did an unpowered pull. Damn! Is that tight as a drum! What are others talking about? Pulled it away from my face and I had my finger placed right over the two air holes.
Tried again and that is much better. Yeah this is a bit on the airy side, but about perfect for me. Now I tried a DTL... not bad, not bad at all. Sure probably too tight for most, but just enough to pull and fill my lungs in about 2 seconds. Flavor for both MTL and DTL is between good to very good. It's a bit on the warm side for 70VG. So first try... not bad at all.
Congratulations on your Minifit. I was a little leary about trying a 70VG. Good to know that it works. Too funny about the fingers over the air holes! Might try flipping it over and using your thumb on the button. Made it easier to use for me.
My DIY "Misfit" sheath...
As shown in the top right image, the sheath holds the mouthpiece just above the surface it rests upon. (dirty restaurant table, messy desk, dusty dashboard).
Cheers
I
As shown in the top right image, the sheath holds the mouthpiece just above the surface it rests upon. (dirty restaurant table, messy desk, dusty dashboard).
Cheers
I
Last edited:
OK, another Myblu guy on board here, lol. I'll be waiting until MVS gets more pods in b4 I order tho.
How many watts we talking? I'm only 8.5W on my mod and the Myblu was about right.
How many watts we talking? I'm only 8.5W on my mod and the Myblu was about right.
Wow! That is a close one. Started vaping between MyBlu and Minifit and they are pretty close. Minifit is a tad warmer (not by much) and produces more vapor and just a bit airier. I'm sure it is over 8.5W, but I am sure the coil is more massive to produce more vapor (so slightly more wattage is ok). So it is very close. If I had to pick one, Minifit wins easily.
So, the wife and I were going out for lunch and I figured I better "top off the Minifits tanks". Charged up the battery (it had just dropped to 2 leds) topped off the 1/2 full pod. It never missed a beat. This thing is the most consistant vape I have ever had. My only concern is how to know where full and empty are. The "manual" says to fill up to 80% and nothing about at what point to refill. A couple little lines on the pod would have made it simple.
Almost forgot. That sheath looks great. Thanks for the pics. I wonder how it would work hung around the neck since the pod would always be upside down. I'll probably give it a week before I start "McGyvering" something.
What? Totally full is too full? Damn, I'm supposed to read the manual? I fill it until there is only one tiny air bubble left and go from there. Well there has been no leaks or anything so far. Although I am not driving up and down mountains nor taking airplane rides. So the air pressure here stays pretty close the same.
Yes that figures about right. Sure is a warm vape for a 1.6Ω @ 3.4v though. I am also vaping from a Vladdin at 1.4Ω @ 3.5v and it is much cooler. Although it uses ceramic wicking and that might need more power to warm up.
Last edited:
Yes - I notice it gets warm very quickly if I (try to) chain vape, though I did cut the airflow in half.
I wonder about the tiny distance from coil to mouthpiece, but then I'd guess many pods are similar in that respect.
I must say I'm really enjoying mine.
Will do. The reason i'm thinking of a new hole, is for the air to hit the middle of the coil...but i'm only theorizing, as I don't have it in my hands.... so theoretically, i don't know what i'm talking about...
How do you tell when it is finished charging?
My old eyballs are revolting against the tiny print of the instructions.
Edit: The lights turn off, too impatient!
My old eyballs are revolting against the tiny print of the instructions.
Edit: The lights turn off, too impatient!
Last edited:
Ha Ha...us old timers, trying to hang on to the modern gadgets...
Maybe it works on a timer... for us old schoolers...
Maybe it works on a timer... for us old schoolers...
I love the way this looks and the size but worry it will be too airy for me. Might have to buy one anyway since they aren’t very expensive (love that about these little pod systems).
- Status
Similar threads
