Kanger T3 vs T3s

[Mimikim1234]

Is there any performance difference between the T3 and T3s? I know about the bases and it's cheaper to change out just the coil rather than the entire base, but I want to know if the draw is any different. I have a T3, and I'm not too happy with the draw (too weak/airy). I just hate to give up on it, so I considered buying a T3s base and a coil to go with it. Will this make any difference? Or should I just let it go?

 

[Penn]

This may not be a direct answer to your question but have you tried covering one of the air holes on the textured base while using it? If that works you could try to permanently block one off. I think someone here once said they use a toothpick to plug up a hole.

 

[crxess]

Correct
Place a toothpick end into 1 hole. while pushing, snap to side to break off.
vape instantly tighter.
Want tighter - block a second hole.
All mine have 1 hole blocked.

T3s should be the same. Same base but redesigned to allow the coil to be removed.

 

[Mimikim1234]

I blocked it off with some transpore tape, but I want it to look nice. I know, I know.
I haven't tried the toothpick yet. I don't think I have any...I'll have to snag one at the next restaurant I go to. I don't know if it would look nicer than the tape.....

 

[Penn]

If you liked the draw with a hole blocked definitely find some way to do it. Maybe cyrxess can take a pic so you can see?

Another thing you may want to consider if you haven't tried one yet is evod. I first tried a MT3 and it gave me less flavor than CE rebuildable. Figuring it could be the length of the tube cooling the vape too much I tried an evod and it works for me. Of course you would have to sacrifice capacity.

 

[crxess]

At first no, but after a bit of use it seems to blend in.

 

[Mimikim1234]

I do like the draw with the hole blocked. I will try it with the toothpick next chance I get. I don't have anything to lose, as far as how it looks. Right now, I'm not using it at all.
Thanks guys!

 

[tiknu]

both leaking get evod or protank or mini protank they are the best in every way

 

[BostonJim]

I converted my T3 to a T3s, just bought a new T3s base. Those you can get at any number of online Kanger suppliers.

No disconcernable difference in vaping quality that I could notice. Same draw, airflow, and flavor as a regular T3. If you like the T3, then you'll like the T3s with the cheaper coils.

 

[Skinny Pete]

Does the T3s use Evod heads?

 

[Tmartin63]

When I first got the T3's they were way too airy, so I blocked two holes. As I used them and cleaned them, they started to be too tight and I ended up reopening the holes. I'm am getting ready to replace the base and go with the T3S just because they are much easier to recoil. I have been using cotton to rewick and they are awesome.

 

[HOPS]

I blocked it off with some transpore tape, but I want it to look nice. I know, I know.
I haven't tried the toothpick yet. I don't think I have any...I'll have to snag one at the next restaurant I go to. I don't know if it would look nicer than the tape.....

I use clear nail polish to block the air holes on mine. Once it dries you can't see it at all...