Kayfun question

[DeathBYzombieZ]

So I just got a kayfun and I absolutely love it. Just to be clear it is a Tobeco clone. It took me a few builds but I go the hang of it, I'm actually vaping a navy nest build I made at 1.8 ohms and Its awesome. my other tank is an aerotank, it vapes well but Ive wanted an RTA for a while and after tons of research I ordered the kayfun. My only concern is the vapor production, the amount of vapor is fine but Im not getting the warm vapor Im use to and love. Does anyone else love warm vapor? Im obsessed with it but Im just not getting it out of the Kayfun. help.

 

[smokin1337]

Get the nano kit you can find it at various sites. It shortens the distance from coil to mouthpiece giving a warmer vape.

And what is it on ? You can always turn up the voltage or wattage and heat it up.

And last but not least build a hotter coil, I like mine around .7 or .8 it's a warm vape.

Sent from my SAMSUNG-SM-N900A using Tapatalk

 

[volume control]

Id say you want to go lower ohm with the build or provide that coil more power. My Kayfun is a warm vape at 1.5ohm on a mech

 

[santoki]

what gauge kanthol are you using? i get a warmer vape off 28 at the same resistance than i do off of say, 32 gauge kanthol. To my understanding, since you need more wire for the same resistance on lower gauge wire, you get more surface area coverage/more juice being warmed up, and therefore a much warmer/fuller vape (and dont risk burning juice by trying to lower the ohms/increasing voltage or wattage if you are on a regulated device). You could also try out twisted wire builds as well, since essentially its creating a thicker wire out of thin wire.

/edit: also, i tend to prefer my kayfun builds at around 1.2 ohms or so, works well for me.

 

[Sthur]

I am running a 1.6ohm micro coil with 30 guage in my tobeco KFL with cotton. The flavor is great and I prefer it right now on my evic running fruity juice and a custom vw setup. I was getting little warmer vape on my mech with same coil. Vapor and flavor is better then my pt2 rebuilds with same coils.

 

[crxess]

Balance:

Resistance
Wicking
Power
Air Flow

Does not matter what any one point is if all the others match.

I have a Kayfun running Beautifully at 1.2ohms and another working perfect at 1.8ohms
Both are using 30ga Kanthal, Micro Coils and Cotton wicking.
Both run at an avg. of 9 watts.