KR808 carts-Questions???

Status
Not open for further replies.

needvapor

Ultra Member
ECF Veteran
May 1, 2009
1,244
1
52
Treasure Coast Florida =)
I was playing with them one day and notices that if you push the rubber insert lower into the kr808 cart that there is a harder draw.. try to push that rubber thing down further into cart. All mine hit way to hard.. I pulled one up last time I was using a preffilled and it seemed alot better... Let me know if this helps! Lori B
 

tulsatggr

Senior Member
ECF Veteran
Oct 9, 2009
88
0
Missouri USA
I don't know if it's important or not but I am using the 901 to kr808 adapter with my xhaler and the cartos are blanks I am filling. The draw is way too easy. Is it supposed to be like that?

Not sure I understand "the draw is way to easy" but we had to drill the holes in our adapters, and two of them were just "that much" too big and we get too much air with those, but the other two adapters work great. The air holes are so insignificantly smaller it is funny it makes so much difference. I do close the hole with my finger a bit that helps.
 

alphafemale

Super Member
ECF Veteran
May 18, 2009
932
5
Marshall, Michigan
I was playing with them one day and notices that if you push the rubber insert lower into the kr808 cart that there is a harder draw.. try to push that rubber thing down further into cart. All mine hit way to hard.. I pulled one up last time I was using a preffilled and it seemed alot better... Let me know if this helps! Lori B

Some of the newer cartos are one piece now.
 

hittman

ECF Guru
Supporting Member
ECF Veteran
Verified Member
Contest Winner!
  • Jul 13, 2009
    61,068
    178,249
    Somewhere between here and there
    I was playing with them one day and notices that if you push the rubber insert lower into the kr808 cart that there is a harder draw.. try to push that rubber thing down further into cart. All mine hit way to hard.. I pulled one up last time I was using a preffilled and it seemed alot better... Let me know if this helps! Lori B


    Thanks! I will go give this a try. Did you push it down to the batting or just down a little? I guess I can just experiment.
     

    OC513

    Senior Member
    ECF Veteran
    Jul 21, 2009
    236
    114
    NYC
    also if you cut the sealed end off one half of a cart condom and then slide it over the 901-KR adapter you can then adjust the airflow thru the hole in the adapter......tailor the draw to exactly how you want it depending on how much of the hole you leave exposed.
    You can also screw a KR cart directly onto the 901 adapter and it gives you a MUCH harder draw than using the adapter.
     
    Status
    Not open for further replies.

    Users who are viewing this thread