Lemo3 wicking!!

[fumar]

Need some help with the wicking on a newly acquired Lemo3. I've had multiple rta's. Griffin, Lemo 1, STM's and a few more. Never had much problem with leaking.

I cannot get the wicking down on the Lemo3! I've tried wicking heavy with the tails to the bottom of the channels, wicking light with thinned tails and in between with no success!

Everytime it just pours juice out the AFC ports.

Any suggestions?

Thanks.

 

[DaveP]

Leaking occurs either from over-saturated wicking that drips into the air tube or from o-ring seals not maintaining a vacuum in the tank itself which can cause the same thing to happen. I'd check the tank seals and the top chimney seal. If air gets into the tank, liquid runs out through the wick. Normally that only happens when you puff and create suction to pull juice out of the tank into the wick/chimney area.

I'm primarily a Kayfun guy, but I own the Lemo and the Lemo 3. Leaking hasn't been a problem for me with either Lemo. Check all the o-rings and maybe replace them from the bag of replacements that comes in the box.

Maybe someone who's a full time Lemo vaper will stop in and help further. Bump ...

Parts diagrams here.
Lemo 3 Atomizer | Get Best Quality of Lemo 3 from Wismec

 

[Maestro]

Agreed. A leaking tank is almost always a bad seal. Find the root cause and you won't have to worry about how you wick it. If you control flooding with the wick, that's a symptom, not a solution.