Merged old Janty Stick sticky threads

[Kelemvor]

@tmbrown, same here. i discovered that in the last few days
its amazing how much vapor the stick can produce with a new atomizer or with onlly the mouthpiece after a few minutes.

as i only discovered this with original carts and the carts i stuffed more loose lately, i hope to get performance back packing them more dense again.


[edit] for a slow down in this oversaturating thing, i sometimes draw a bit extra heavy for a split second, seems to free the atomizer most of the time, but also draws liquid dangerously near the mouthpiece.

[edit2] sometimes i just pullout the cart+ mouthpiece and draw directly 2 times if nobody is looking

 

[FlaCracker]

At what voltage does the stick shut off and blink red for you to change the battery?

 

[lm921]

At what voltage does the stick shut off and blink red for you to change the battery?

i did not measure it but 3.2 is as low as you would want to discharge this type of battery (10440)

 

[gyrixx]

Hmmm.... Its day 4 for me now and I keep getting about 10 "good / heavy" clouds of flavor then it feels like I have to "nail" on the initial suction... Then pull the rest and still... Almost no "flavor" but tons of throat-hit... I was beginning to suspect a disconnect between the cart filling & the atty so I just popped in one of my spare BE112 attys and have hit the 30 mouth-full mark with the same nice hit / draw...

Bad JS atty perhaps? Anyone?

 

[Zestok90]

Just an observation and some thoughts about the V2 and the 801 carts. I find that I get very good performance from my atomizer when I top off, and that lasts for a while. Then the performance starts dropping off a bit, you have to pull longer to get the vapor/TH you want. I suspect that the atomizer is now saturated and just at the point where it is hovering on the over-saturation point. I think this affects how the coil works. I think it may be supplying too much liquid to the coil to allow effective vaporization. What I've started to do is, when it gets to this condition, pull out the cart, install just the whistle tip, and vape for a while, working off the juice already in the atomizer mesh. I can get at least 20 good drags in this condition, with good vapor and TH. When that starts to taper off, I replace the cartridge and I'm good to go for quite a while longer, usually until the cart is nearly completely empty. I think this also minimizes buildup on the coil. I'm not sure this would work for every atomizer/juice combination, but it seems to work on mine fairly consistently, and stretches my juice out pretty well.

I'd be curious to see if this works for anyone else.

How do you get just the whistle tip, I tried to oull mine off or the cartridge, but it doesn't seem to wanna budge, do you just gotta yank at it. I don't wanna break it, seeing as I wash out and reuse all of my carts and right now I only have 5 that fit the 801s and thats what came with it

 

[VaporX]

Anyone mind posting some V2 pics?

maybe close up of whats different and some overall shots please

 

[gunz4hire]

They look identical I actually thought I had gotten 2 v1s again when I got them today. The only way you can tell the difference from the outside is the battery cap had a bigger middle notch. But if you want pics I can still do that but it really is identical.


Gunz

Also the atomizer shaft is might tighter...not as much wiggle room.

 

[VaporX]

any visible difference to the button? and have you had any paint wear off.

id still love a pic of the new cap if you are willing

 

[gunz4hire]

Here you go!

No paint wearing but I just got it today! The button feels similar but not 100% the same as far as that goes. I did try dripping with it today and that seemed to work just fine but I didn't try that with my v1s. I also noticed that there wasn't any liquid on the outside of the atty when I pulled it out after using it this afternoon!

Gunz

It's kind of hard to see from pic 2 about the battery cap but you can fit a dime in there to turn it now. It has a much wider cross to it.

 

[gunz4hire]

Here's a better pic of the cap

 

[1010chrissy]

O.K. Just got mine today but it seems like the v1 replacement (the 2nd one I got) works and vapes better than the v2. I seem to have some button issues, but not sure yet. Will get back on that after a few days of use.

 

[VaporX]

Thanks Gunz,

the juice on the outside of the atomizer i get with the v1 often, glad to hear its better on v2

keep us posted on the paint my v1 wore alot of paint off within a week and continues to do so.

last question did you get a usb cable with 90 degree one or standard

thanks again for the pics

 

[gunz4hire]

No problem on the pics I didn't get any usb cables I sent in my v1s with button problems for replacement and just got new bodies but nothing else.

Gunz

 

[geeker]

Is the cross on your cap sort of catyywhompus?
I mean, the lines not exactly perpendicular?

 

[gunz4hire]

Yeah I guess after looking at it closer you could say that more of an x that is squished a little but the line going down the middle is much bigger.

 

[Flip7990]

After receiving the V2 today, I have to say that the switch looks the same and I fear that it will start to peel off again. Only time will tell. I do like that there is no longer a strong plastic smell.

 

[gyrixx]

Hey, tmbrown327 may be on to something here... I NEVER would have thought that I was OVER-saturating my coils/mesh!!!

I didn't completely understand what you meant by "whistle-tip" but I just popped OUT one of my carts then just "set" it gently in the top of the atty so I could feel a good seal but so that the cart packing wasn't touching the mesh at all.

Than, exactly as described, I got MUCH BETTER Vapor/TH!!!

Very good insight!!!

Thanks a bunch!

 

[tmbrown327]

On my carts (from both Janty and someplace in China), the white part that holds the stuffing just clicks into the mouthpiece (whistle tip). Yours might be glued or something, not sure. An empty cart (no stuffing) would do the same I guess.

 

[tmbrown327]

My V2 (an additional order, not a warranty replacement) came with a much longer USB cable, but not 90 degree.

 

[big_gun]

I ordered the Janty Stick V2 today, and like a dummy, ordered non-nicotine carts. Well, I emailed them to swap out the carts with nicotine versions.

Sometimes I am so dumb!